FrSky Yaapu Telemetry Converter Cable Pixhawk to Taranis X9D Plus QX7 Jumper T16 Smart Port R9 Slim+ R9 X8R XSR R9M X4R Receiver

I just set this up on a plane with an F35 or Wing 10dof flight controller and an R-XSR. It seems to be doing everything that it's supposed to, but I hit some snags setting it up. First, I found that it only works when the RX is flashed with SPort firmware. It wouldn't work with FPort. Next I had to set the serial protocol to 4 in Mission Planner. Then go to the telemetry set up in the TX radio and discover sensors. Once the sensors are detected, go back into Mission Planner and set the Serial Protocol to 10. That will allow the data to flow though to the Yaapu script. I hope that helps somebody!

Works really well. Using it with a Matek H743-wing with ardupilot. Funny thing is, you don't need the red or black wires. Only the TX and Rx on the Uart and the one S.port wire. I removed the red and both black wires.

This cable is a must-have for Pixhawk and FrSky integration, enabling seamless telemetry display on OpenTX radios via the Yaapu Lua script. In my aerial tests, the data was transmitted reliably up to 1 km, with no signal loss or latency in reporting critical parameters like GPS, battery, and altitude.Critically, however, the cable is rigid and difficult to route in tight UAV airframes, leading to awkward bends or poor space optimization. A silicone-sleeved version would elevate the product to professional-grade standards.Still, functionally flawless and highly recommended for any FPV or fixed-wing pilots needing reliable telemetry feedback.

Well made with silicone wiring and a few different setups included. With a Pixhawk, it's plug and play! Pop one end into the Sport on an FRsky RX and the other end into Telemetry 2 of the Pixhawk. Change Serial 2 protocol from 1 to ten to enable pass through and you are in business. The install Yaapu's excellent LUA scripts and you are in business

had to modify and resolve 2 of the connections. then it started working for my rsxr reciever

use with a FrSky X8R recever, the Pixhawk and Jumper Pro 16 I can get gps maps and Telemetry on my Jumper Pro 16, It is a vital tool for me. I have three

This worked just perfect with my pixhawk and Taranis. Its small well put together. Has extra cables if needed.If I need another this is where I'll come.

Works only with fr sky x8r reciever