2pcs 99cm / 3.2ft Metal Flexible Inner Shaft Cable for Bench Grinder Drill Press Flexible Shaft Rotary Motor

I ordered this to replace a cable that broke in my " GOXAWEE " G4123 Hanging rotary flex shaft tool. The manufacturer doesn't provide a list of compatible devices, but all you need to do is measure the length and verify that the ends of this one are similar to your flex shaft cable. Length is 38 3/8 inches. I would suspect that this cable will fit most of the flex shaft tools available here on Amazon or eBay. You get two spare cables ( with new set screws ) which is a good value and they seem to be made well.

This product is a replica of the one in my ancient Vulcan flexible shaft grinder that I purchased in 1991 for $119.99. The inner shaft cable broke loose from the collet on mine most likely because I never disassembled it and greased the shaft as the instructions indicated should be done. Then I discovered this replacement on line. This saved me a ton of money and I didn't have to discard a perfectly good grinder motor. Note the replacement has only half the windings around the shaft cable. The only "con" was the cost of the grease recommended to be purchased with it. The Foredom flexible shaft lubricant. $9.99 for a 1oz tube. You can search and find it at half or less that price from other sellers.

Works great and easy to install. Now I have a powerful tool to help me with my rock crafts.

I have ordered these a couple of times now . They don't seem to last very long but for the price I am ok while I learn

They are a little shorter than the 1 I was replacing but I think they might work on a different rotary tool setup

I picked up this unidentified motor and flex cable at a secondhand store years ago. It may have had some sticker or model number at one time but it did not when I bought it. Well, the inner cable broke. I tried different replacements that look like they might work, but did not except for this one which appeared to be an exact replacement. The save me a heck of a lot of money to replace the whole thing. Plus it comes with a spare, if I should get in this situation again.

This inner shaft is a little too short to connect to the handpiece. It is almost long enough. Close, but no cigar. I have another shaft which may work. I may also be able to shorten the shaft, but it still a pain.

Gog my vevor rotary tool up and going again. Used a couple weeks so far holding up great for me and I'm definitely hard on stuff.