Fender Flares, Fit 2007-2013 Chevy Silverado 1500/2007-2014 Silverado 2500HD 3500HD, 78.0"/97.6" Long Bed

I still have it. I can’t use it. It won’t fit on my truck. I have two trucks. It won’t fit on either one. All I can say is if it would’ve worked about a good deal.

Ordered these put them on my 2010 chev and they fit great ! The seals are kinda a pain to put on but over all they have been on my truck now 5 months they are doing the job meant for ( cover rust and help protect ) , I noticed though a seal had fallen off , I contacted them to order new ones and the costumer support sent me new ones at no cost , very pleased and happy , didn't expect that after months , very pleased with this purchase !

Complete GARBAGE! Instructions say to "peel two to three inches of red vinyl backing away from edge trim tape. Applying the adhesive side of the trim to the top edge of the flare" there is no adhesive strip on the tape. The rubber tape supplied with the kit is u channel and needs to be glued to the flare or it will not stay in place. Then it is stated in the instructions if you use any kind of glue the warranty is void. The fit is terrible and the flares have molding lines that look like crap! Not worth the aggravation to return, they will be deposited in the closest dumpster!!!! Stay away from this junk!!!

Exceeding expectations. Can’t wait to install

These look great on the truck. Installation went well. Took a couple hours. There is a slight gap in a couple corners but it went thru the car wash just fine. Hoping the heat of summer will make them mold closer to the metal. I would recommend these.

The installation instructions were difficult to follow with words missing or a whole sentence cut off. You will need some general knowledge to be able to follow the instructions. Product looked good when installed, but time will tell.

I put these just on the front fender of my Silverado and they fit great! It took less than 3 minutes to install, and since this is screwed directly to the truck it fits nice and tight. I was considering squeezing some plastic binder or adhesive on the inside, but I don't think it is needed. The flare fits very well.

The rubber trim does not stay on, and when you go to mount them , they won't sit flush against the body. So if you want a crappy, cheesy look on your truck, buy these.

The four fender wheel moldings installation took about 2 1/2 hours with the most time consuming part being the removal of the original mud flaps. The seal around the fenders was excellent with the exception of a slight gap on the leading edge of the rear moldings. Also, with the removal of the front mud flaps, there is no longer a lot of protection of the doors. It is strongly recommended to order additional flexible mud flaps to protect the lower door sections

Very poor fitting product.