Anki HappiGo ANKIA 40-LED 40W Motorcycle Tail Light Integrated Running Lamp Brake&Turn Signal Light with License Plate Bracket for Harly Motorcycle Street Bike Cruiser Chopper (Black)

Insulation was super simple. I welded a piece of flat bar stock to my mini bike frame. Drilled two holes and screwed it on. As far as wiring that took a little bit more patience and time, especially because it's a mini bike and it wasn't designed to have the lights like this. The fact that it does your running light. Your brake turn signals, license plate light. Everything you needed to do in a small package, the value for money is through the roof. The quality on this thing is superb. The wires on it have plenty of length and they're of good size and quality so you shouldn't have any problem wiring it to anything. And if it's going on a normal motorcycle that already has lights, ease of installation would be incredibly easy. Also, as a side note, I've ridden in the rain quite a few times and in the snow and so far there is no moisture or condensation of any kind inside the light.

Great looking tail light looks amazing on my motorcycle easy to install if you know a little bit of wiring

These lights were a fantastic replacement for my Honda rebel 300, if you have a little bit on patience and know how to wire things you can remove the tail light ont he honda and replace it with this. Looks really nice. The only thing I would let you know is you will have to swap the blue and orange cables because it will have opposite turn signals. The only reason I gave it four stars was because some of the leds stop functioning under a year. That being said the price is cheaper than replacing bulbs so I just replaced it again.

Very good quality, have had time to put them on yet. But by just looking at them ,I have no doubt that there going to be great

Custom rear light with brake light turn signals and plate light

I used this as a basis for a custom tail light on my Kawasaki H1. It seemed to work great for a while. Now it is apparently cutting in and out. I managed to tape the wire to the side of the shell and get it to turn back on. Its worth noting that the Kawasaki H1 is about the worst environment for any piece of electronics, so I am not going to discount it too hard, but if your bike vibrates a lot, you may experience issues. Looks cool when its working. I will probably break it open and attempt a repair, but if youre not up for that I would plan to get something better built.

Had to return because the United States license plate holes do not line up with the bracket.

So I ordered these lights to put on my little mini bike I've been building. Wasn't too sure on the fitment, but when I got them and installed them, they look amazing. The wiring is so easy and simple. I can honestly say I am highly satisfied with the outcome. Also, the lights are great illumination! 5 stars 🌟 🌟🌟🌟🌟 I'll post a video once I get the whole bike done 😊

Fácil de instalar

Not even a year of use and the electric wires burnt out. Perils of Chinese made cheap products.

A única coisa é que algumas porcas duraram 10km, o tempo de sair da mecânica e chegar em casa, então tive que trocar por porcas auto-travante.

The tail light is an additional to the existing stock light. Installed this to give additional indication to the following vehicles especially during a gloomy day or night time travel. This tail light serves its purpose well..

Prodotto molto bello, facile l’istallazione (ci vuole un po’ di manualità) l’effetto di notte è molto bello e si vede bene anche da lontano. Anche le frecce funzionano bene. Consigliato . Non so quanto dureranno perché l’ho appena montate ma spero a lungo!