Antrader Lock Clasp Buckle Latch for Wooden Case Toolboxes with Screws Pack of 12

Works amazing for power ranger helmet, used rivets to install them to the plastic helmet

Very content,They are small!! But perfect for my jobe. I did not use the screws. I had to adjust the hook fastener some and it was easily done. My 8inch band saw looks very nice with the properly sized stainless hardware its an older delta. I also replaced all screws with stainless Steel.

Clip measurements are as described, and pretty nicely finished for the price.Note that the end of the spring hooks under the latch mounting plate (see the listing picture of underside of the latch). I wasn't able to get the latches to work in my application, since I intended to rivet them to a metal surface. I couldn't get them to sit flat enough because of that hooked spring end.

This item is made of metal and small in design. Screws are included to mount onto any surface. It does take effort when installing to make sure the latch and hook are spaced correctly. Too close together or far apart and the latch is worthless. No template is included so you have to figure out a spacing of the 2 pieces that will work. Seems to be manufactured of quality materials. No issues since I successfully installed with correct spacing of the 2 parts of the latch.

These are ok little clasps. A few of them were kinda tight an didn't spring like they were supposed to.

I made my own cornhole boards, they fit together and latch. These latches worked great. Will use again.

These latches are junk. They are made of VERY THIN/FLEXIBLE tin metal. They ruined my project. Finished my build and applied the finish to it. Marked and drilled pilot holes for these, tried to install and 4 screws in a row broke 3/4 of the way in! I was using in pre-drilled pilot holes matched to the included screws and they broke 3/4 of the way in! Now I have stubs sticking out preventing me from shifting the latch to the side to cover the broken screws. Now I have to try grinding off the tiny stubs, drill new holes, patch the old stubs/holes, refinish where the old holes/ground down stubs were, buy new latches/screws and finally finish the project that should be finished now!! I was refunded for the latches, but the seller should be paying for my time/labor/materials that are now required to repair my project!!! Please heed this warning and buy something that will work as described and not destroy the project.

Good value