Creality Laser Engraver Cover V2.0 Fireproof and Dustproof Protective Enclosure with Exhaust Fan 4000RPM Pipe for Most Laser Cutter, Insulates Against Smoke, Odor and Noise Eye Protection720x720x400mm

Overall a very solid enclosure. It's easy to assemble, spacious, and does a good job at extracting fumes and blocking most of the laser light.There is a bit of light and smoke leakage from the bottom, as this enclosure lacks a floor. Easily solved with a bit of duct tape however.

I have little to no ventilation in my out door office, so I bought this guy to vent fumes out a hole I'd drill in the wall. The fan isn't quite as powerful as I would have liked it to be, so I ordered an online 4in one and duct taped it to the hose. There is literally zero smell from engraving tumblers or smoke from cutting wood etc.The fit around my elegoo phecda 20w could not be better. Very impressed!

It's a simple lightweight cover that is super easy to set up. I am a little disappointed with the exhaust fan. I have a second fan installed and even with both of them running and the cover closed you can still smell smoke. It's not bad and definitely acceptable for my purposes but I was expecting better.

Purchased this for my XTool D1 and it fits over the machine with plenty of room very sturdy and the quality of the cover is amazing. Very simple to assemble

Every time I would run my Creality Falcon 10w engraver, my son would walk into the house later, breathe deep, and say, "Mom's been running the laser cutter again! It smells like a campfire."Needless to say, you shouldn't run this thing in your house without an enclosure like this to vent the fumes outside. Now that I have this, I vent the smoke and fumes out of a window. I cut a hole in a piece of corrugated plastic board and duct-taped the vent hose into the opening. I then close the window on the plastic board, and all the smoke goes outside. The board is the same size as the partially open window so no smoke seeps back in — no gaps.I am very glad I purchased this. I live in an old bungalow and don't have a garage or shed. I have to do all my crafting in the house. This was a must-have accessory for me.

Easy assembly but I was disappointed with the amount of airflow that it actually moves.I vent it outside but when I go to the outside vent you can barely feel it. I ended up ordering another inline fan for an additional $25 which I'm hoping will help. That one will arrive in three days.It works OK for not-too-smelly stuff, but definitely not when I am cutting wood

I was a little skeptical about using a tent style cover for my laser machine, but this works great. It was easy to assemble and does what it needs to. The vent fan is a bit weak, so I hooked it up to a stronger smoke removal system (an inline blower and carbon filter both sold off of Amazon for greenhouse use), and it works very well. The orange laser filters don't really do much filtering, so even when closed good goggles are a must. Still, it's well made, easy to use and does the job.

Works great