Flashforge Adventurer 3 Series and Adventurer 4 Upgrade Hotend, 3D Printer Parts High Temperature Nozzle Assembly (0.6mm-265°C Nozzle)

Har inte provat den ännu. Ser ut som original så det bör fungera utan problem. Snabb leverans.

Exelente quedó a la perfección

I purchased this 0.6mm hotend to use with the flashprint vase mode. I found that the 0.4 models were just a little too thin, with the 0.6 end they definitely have a lot more rigidness to them. Detail wise i haven't noticed and reduction on detail, but then i have not printed anything more intricate with this nozzle other than a few Christmas trees. Swapping over the nozzle on an Adventurer 3 was quick and easy - the only tip i would give it that the printer does not recognise the nozzle until a full power cycle of the machine is completed and then it worked just fine. Remember to change the nozzle settings in the software before you print!I hope that you found my review helpful.

La idea de tener un 0.6 a 265, suena increíble reduce mucho el tiempo de impresion y por ende el costo de la factura eléctrica, el gran problema que tiene es que cuesta mucho que encaje correctamente al parecer la empresa tiene muchos problemas de control de calidad en sus productos (la propia impresora flashforge) le he tenido que remplazar varias piezas en menos de un mes y muy poco uso. si el problema persiste voy a tener que devolverla espero que esto sea solo un caso aislado.

Bought this after the original nozzle stopped heating. It's a direct plug in replacement so really easy to swap out. I installed, recalibrated in case it had a slightly different length, and it worked straight off with no problems.