ZhongzhenRC Light Bar 15 LED 2.95 Inch Aluminum RC Lights RC Crawler Accessories for Axial SCX10 Traxxas TRX4 TRX4M Arrma Senton Redcat GEN7 1/10 1/18 Scale Rock Crawler Truck RC Car Roof Light Kit

High quality construction, super bright and a module for switching between fast strobe, slow strobe or just on. Automatically starts off when you plug it in to the car too, so you can’t accidentally leave it on.

Éclairage incroyable.Vraiment très efficace.

Well worth the money, very bright, 3 modes and the off position. switchable with the button on the board and third channel on the radio

on off switch didn’t seem to work, had to cut the wires off of the switch and jus wire it straight to my receiver to the light…

Update 2: 6v is perfect and does not heat up nearly as much.Update: Be very careful where you mount these. They got very hot even to the touch over time. It takes a minimum of 10 minutes but does continue to get hotter. Its to be expected with the output but it will soften PLA 3D printed parts at 7.4V. Its rated for that and higher but the manual does says optimal is 6.0V. I was worried about the wires getting warm but after 20 minutes, it was only the metal on the lightbar itself.Put two of the smaller light bars on top of my Cross NT6 and it's incredible. Extremely Bright. Even with the vertical mounts in the roof rack, it still lights up everything in front of it. I did not use the included controller, it was fine but preferred a simple on and off. The included controller does on, breathing and strobe. Mounts are metal, rear fins are metal and it even has a see thru piece in front of the LEDs. I assume they will draw some voltage but being on a crawler and LED I am not too worried. Hopefully I can update after a few runs. Very happy with these. Looking forward to adding more to my other rigs.