Funrous 100/50/20 Slabs Aluminum Coin Storage Box Case for Slab Holders Storage Collection Supplies Coin SlabStorage Box for Collectors(20 Coins,Black)

Very good quality. The foam cushions on the inside is thick and durable. The see through cover is a nice touch to make it look nicer. Box itself is durable.

Perfect case aside form one issue if the coin case is a little to wide it’s hard to lock it shut other than that served its purpose

Too narrow, coins don't quite fit, you can make them fit but then the middle of box bulges and it doesn't close right. The rivets on latches are loose as well, not worth the money

I liked the aluminum construction and light weight. The clear top is a nice touch as well. The case itself is good and solid but the locks and hinges do not appear to be very durable. This case is fine if you don't plan to travel with it or expose it to conditions of duress. I am using it to store my NGC graded American Siler eagles and the cases fit just fine.

I have purchased several of these, in both 20 and 50 coin sizes. They hold PCGS and IGC slabs perfectly, but NGC slabs are a tiny bit too thick to fit properly. Fortunately, I don't have many NGC slabs. I have been collecting coins for a few decades now, and have switched to this type storage box exclusively for graded coins. I love them!

The thought of this case is ideal but not sure where they got the measurements from as the slabs do not fit securely in the slots. Slightly wider than the slabs which makes them slap together.

It was a little bigger than we thought, but quality was perfect for as little as it cost

The box looks good , quality is decent. No slabs from any grader fit. The slots are 3/8 to big so the slabs don't fit tight at all and fall right over. It's basically useless in performing the only thing it's supposed to do. Wish I read the reviews first, but it's a storage box, I didn't imagine the slabs its made to fit wouldn't fit. Lesson learned

Barely strong enough to support full weight - dont bump it! Ok if half full! I had to take out a board from between foam sections in order to jam-hard 90% fill. Still too much stress on holders - I`m now scared to look. Maybe ok for ANACS holders(possibly) with little copper coins(maybe). Wouldnt buy again.

This item doesn't fit the standard NGC/PCGS slabs. The width is too wide. Were that not an issue, it would be the perfect coin holder.

The product in general is great but while putting the slabs in place it shows that it isnt made properly especially when you put them both sides. The middle section should have been thinner and the sides that hold the slabs should have been slightly bigger for better usage