Microwave Oven Universal Mica Wave Guide Cover Sheet 150mm x 100mm, Cut To Size

This was very easy to fit provided you take time and do it correctly. I fitted this to my Whirlpool JT369 but this will fit most microwaves. Just measure the old one before you buy. You will save money by cutting to size to suit your particular microwave. Do not use scissors to cut the mica or it is liable to shatter. It is thin, it is meant to be thin. Best way is to remove the old one and use it as a template for the new piece. Use a flat protected surface to cut the mica. I used a chopping board on the kitchen table. ( I take no responsibility for you cutting into your wife's new table so make sure you protect it.) Place the old wave guide cover on on top of the new piece of mica and draw around it using a fine point marker pen. Make sure you also mark where the screw holes are. Now using a straight edge and a stanley knife with a brand new blade inserted, cut around the lines you have drawn. Be careful with the knife, again I take no responsibility for your trip to A&E to have stitches inserted. Once you have cut your new wave guide to size, use a sharp pointed object to make an impression where the screw holes would be. I used the tip of a very thin pozidrive screwdriver to do this. You could in fact use the screws to create the new holes before fitting. The screws on my microwave are self tapping screws so when I came to fit the wave guide back on it was fairly easy to enter the screws into the recess I made in the mica and start turning it with a screwdriver and it made its way through. If your screws are threaded then you may have to carefully drill a hole to size. Whole job took about 15 minutes to complete.

Does the job, saved the microwave.

Easily fix your ovens when they have sparks, so that instead of throwing them away , just replace this cover sheet and its back and up running. Mines happened for the second time but everytime the sheet lasted for few years atleast. Worth the money.

Works as it should.

The material is first class and in fact is of a better quality than that fitted to the original microwave oven. Would recommend this company.

Perfect replacement mica board wave guide. It's easy to cut to size with sharp scissors if you use your old one and trace the profile. Easy enough to fit into the recess parts on the side of the microwave as well. All done within 5 minutes and a perfect working microwave again.

Brilliant, and all sorted easily

Fit is difficult as the material was too thick for the retaining lugs on our microwave.A pity as the quality is good and a good price too.