Mosuch Battery Holder for (8) AA with Standard Snap Connector : BH383 (1)

The media could not be loaded. I needed a new one for my telescope, it’s over 10 years old and the one I had was rusty. I bought this one and bam- it’s working again. Easy to install, still working perfectly it fits perfectly for my telescope so that was perfect! It’s sturdy and so far no issues! Hopefully with this new one it can last another 10 years!

Nice and compact, the battery snap on the top makes it easy to integrate into projects. I used this for a project in which I wanted to replace a standard 9v battery with rechargeable AAs (8 of which give you between 9 and 9.6v). Of course, this is much larger than a typical 9v battery, but for a simple rechargeable 9v equivalent (and one that'll last tens of times longer), this fits the bill nicely.

great article, a good purchase I recommend this article

I use this AA battery holder to power a Powerbuilt 648539 Computer Memory Keeper using 8 'AA' rechargeable NiMH batteries. I prefer this solution over using a disposable 9-volt alkaline battery since I already have plenty of fully-charged NiMH 'AA' batteries on hand, ready to go. With 8 NiMH batteries loaded into the holder, the output was just under 10.5 volts which is sufficient to maintain a vehicle's radio pre-sets, resettable odometer mileage, clock setting, and ECU memory when the vehicle battery or the alternator is being replaced.I've tested this battery holder and it works as advertised. Since 'AA' batteries are somewhat heavy and might be prone to falling out of the holder if handled carelessly, I pre-emptively secure the batteries in the holder with a single rubber band wrapped taut around the whole thing. The snap connector portion of the holder is nice and secure.

The items are great but i only ordered 1 and got 2 but neither fits my Fox Pro Fury battery compartment. they both are too wide. Can you help get the right one and return these??ThanksVirgil Otto 513-524-8908

I purchased this item as a stock part for future use on electronics and robotics projects. However, it was pressed into service early on to illuminate an automotive turn signal bulb as dramatic back lighting for a table top photo shoot of a large light bulb that I shot for exhibition on two photo Websites that I display images on. An ideal and compact 12 VDC power source for any such project.

Not a lot to say, thankfully. I mean, it's a battery holder. Works as advertised. Arrived with no problems, I put batteries in, hooked it up to a small propeller and everything worked as it should. Good product and pretty cheap, can't complain about anything!

It was a good battery case replacement, came just as described and works well