Key Fob Keyless Entry Remote fits 2004-2016 Toyota Sienna (GQ43VT20T 5-Btn)

Product came with a website link to programming instructions. They were a little more difficult to follow so I included some easier ones here.What was not made clear at least to me in the instructions is you have to reprogram all of the remotes. So the first time I did it I only the new remote worked. After reentering programming mode I reprogrammed all the remotes. I used the instructions as follows.Programming Notes:Remove the key out of the ignition cylinder. Keep driver’s door open and unlocked, while leaving all other doors closed.Within 5 seconds or less:– insert the key in the ignition and then pull the key out– insert the key in the ignition and then pull the key outWithin 40 seconds or less:– close and then open driver’s door– close and then open driver’s door– insert the key in the ignition and then pull the key outWithin 40 seconds or less:– close and then open driver’s door– close and then open driver’s door one more time– insert the key into the ignition cylinder, but leave it inside at this time– close the driver’s door– turn the key to ON position, but do not start or crank the engine– turn the key back to OFF position– remove the key from the ignition cylinderWithin 3 seconds, the power door locks should lock and then unlock automatically indicating that you have successfully entered the programming mode. Return to step 1 if the door locks did not cycle at this point.Within 40 seconds or less:– Simultaneously press lock and unlock buttons on the remote that you are trying to program for 1.5 seconds– Let go of the lock and unlock buttons, and then press and hold the lock button for 2 seconds. Within 3 seconds, the power door locks should lock and unlock once automatically, indicating that you have successfully programmed the new remote.If the door locks cycle twice, then there might a problem with the transmitter or the procedure. In that case, repeat step 6 or verify that you have correct and properly working transmitter.To program more than one remote, repeat step 6 for each additional remoteFinally, open drivers door to exit programming mode.

Received product today. I followed instructions by Jim and Tom Thomas, and it worked perfectly. Only the lock, unlock, and alarm buttons worked. Remote is for a 2006 Toyota Sienna CE.

Good and it works

This is a great low cost option vs a dealer/locksmith programming this. The best quote I got was $275. I am so glad I ordered this replacement. Programming was a bit challenging and I was unsuccessful 2 times. Frustrated, I googled and found clearer instructions which I was able to follow and first time through got it to work.

This worked perfectly for our Toyota Sienna when the clicker died. We couldn’t get the old one to work, and swapped it for this. But this one works perfectly.

i want to return this item they dont work

Added these to a recently purchased Toyota Sienna and pleased with high quality like stock. Included 2032 batteries (same as stock). The included instructions are easy to follow and programmed in quickly and on my first try. It's a ttricky sequence, but once you've done it it works

Easy to sync to vehicle. Decent range and battery life. Quality is so-so as they don't have a very long life. Better deal than the dealer.