Layer3D Fingerboard Mold - Made in USA

Allows me to make fingerboards very easily and had no shaping issues

Worked perfect! Im my sons hero! Yea I'm a Bad ass Dad! Thanks again

The quality was horrible, it was uneven, broke within an hour. DON'T WASTE YOUR MONEY!!! Buy a better one even if it's more expensive.

it might be user error, but when I was clamping it up the structure of the way it was printed broke a hole in it so I had to clamp it with a vice. You can tell it was 3D printed, but that the infill was a really low percentage. it still kinda works but I thought it would’ve been stronger. I have been trying to make more boards but every other one seems to get big air bubbles in the center. plus the concave is kinda medium depth, I wish the kicks were higher.

I think most poor reviews that have been left on this are from people that have zero to no skills to figure things out or that the rough texture isn’t going to affect the wood. It’s 3d printed so it’s not perfect, I had to help my son clean out the holes on the part that you use to drill the truck holes. But for $20 it’s pretty cool and fun making different shaped boards with my son.

Son used this over the summer for many skateboards. Plastic is hard enough to use clamps but do not tighten them down too tight or else the plastic will start to crack. You should clean any excess glue off the mold prior to each use. Overall, good product for the money.

This is the fifth mold I have bought and this one is by far the best. The size is perfect, the kicks are about 25 degrees and a good amount of concave. I also like the way the two half’s fit together. The small lines in it don’t show in the finished deck.

Collapsed under the pressure of a clamp, even though I sandwiched it between pieces of 1x4.

Funciona muy bie, aunque al usar una prensa se debe tener cuidado de no apretar demasiado ya que el material no es tan rígido y puede quebrarse...

I have a few molds and I can honestly say this is by far the best 👌 The 3d print quality is unmatched compared to my others, very impressive 👏

El producto trae 3 piezas y solo venían 2! Muy mal!

This product is low quality and is not thick enough for clamping the two surfaces together to get good lamination of the veneer layers to create a good quality finger board. The 3d printing has low infill to make it structurally sound.

Had to wait before i made my first fingerboard with the mold to do a review but lemme start off by saying BOTH shipping and delivery were incredibly fast and ahead of schedule so that was awesome. As the first review i must say this is great straight forward very inexpensive fingerboard mold worth the money! Im very happy with this purchase being one of two only molds on Amazon CA.