Tondiamo Rubber Stamp Sheet for Laser Engraving Machine, A4 Rubber Stamp Sheet for Laser Cutter Soft Rubber Sheet to Make Rubber Stamps, 2.3 Mm/ 0.09 Inch (Light Gray) (Light Gray)

My first time making a rubber stamp with the Glowforge Aura. This rubber cuts smooth & delicate details are not lost. These stamps I made was only 1" in diameter. There is a lot of dust that need to be cleaned up & mini vac is highly suggested. Amazon says the material is .09, but my caliper says .08. So you may need to test yours. The settings I used were: Unknown Material: .08 Engrave: 100 / 10 / x4 Cut: 100 /10 / x10 Twice The cutting is where it got tricky. 10 passes, the limit on the Aura, is not enough to get through the rubber all the way. What I did was do a first Cut & Engrave session, then I changed the engrave layer to ignore so that the only thing left was the cut layer & hit “Print” again. Even this was not enough to go thru the rubber completely. However, It was so close that I was able to “pop” out the stamps. You could probably do a third round if you want.

Great products

Worked great with my diode laser.

Engraved and cut so beautifully in my Glowforge!

After having terrible luck with the red/orange rubber sheet they sell, and they have the same description, I was relieved to see that this engraves well without all of the horrible gray goop buildup that happens to the red sheet. Something should be done about this.