Anzo USA 211049 Ford Excursion Chrome Tail Light Assembly - (Sold in Pairs)

Installation is simple enough, but the fit was not as easy as I expected. The rubber seal was problematic.PROCESSRemove the OEM rear light assembly (4 Torx screws), and disengage the bulbs. (You will re-use the bulbs).New Rear Light Assembly: Remove the tape cover from positions 2 and 3 ... position 1 is not used.Work the rubber seal over the outer bands of the new headlight. If you do not do this, the OEM screws will not engage in their slots!It took several tries to get all 4 screws to engage due to the poor fitment of the rubber seal. After a few tries, I got the screws to engage. I had to continually work the rubber seal to get the fitment I expected. I ended up replacing the upper inner screw (closed to the rear door) to make it work.Decent product, appears to be well made, but the difficulty dealing with the rubber seal gives it a 4/5.

Installation was easy for the most part until you get to the screws. I couldn't use the factory screws, I had to go buy longer ones at Lowes. The seal around the lights is super thick, which is good, but it takes alot to get the right fit. The lights look great though.

Look nice, fit is definitely not the best. Has some tabs that need to be removed. Cheap rubber around that doesn’t sit flush. Good looking cheap cover but much better options out there.

We replaced old lights on my husband's 2003 Ford Excursion with these, looks so good and fits perfect. Easy to install as well

Great Quality. I did have to do a little modifications to get them to fit snug on a 2003 model.

Great

Great buy looks great on vehicle.

Perfect replacement for my 2004 Ford Excursion XLT. It gives my SUV a more modern look than the stock look.