PLEASE NOTE: Recognized the NEW LOGO is in the middle of bottom.This new upgraded tempered glass surface is incredibly sticky at high temperatures for plastics such as PETG, PLA, and ABS. Once the print has finished, DO NOT immediately try to remove the model from the glass bed with force!! This glass bed must come down to room temperature for the advanced surface to "release" the model. Attempting to forcibly remove the print from the glass bed at high temperature WILL DAMAGE the proprietary surface.Temperature settings for different filaments: 1. PLA:50-70ºC 2. Flexible filament: 50-70ºC 3. ABS:100-125ºC ( 110ºCis recommended ) 4. PC:100-130ºC ( 120ºC is recommended ) 5. Nelon:90-120ºC ( 110ºC is recommended ) 6. PP:100-130ºC ( 120 ºC is recommended ) 7. PETG: 50-70ºCSpecification:Material:( Special Glass + microporous coatings )Item size:( 235*235*4MM)
I**.
Just look elsewhere
This is imitation of the glass Creality provides with the Ender 3-V2 printer. A bad one. PLA would not adhere properly, first layer lift, just terrible. While everything worked great with the same settings and original glass. Moreover the one I got was also warped (glass itself wasn't straight!) good luck leveling this! Returned after wasting a day trying to understand what is wrong.
H**N
good but got scratched after first trial
will need clips to secure it and make sure to level your device before, since it will get damaged easily.
R**R
Plateau tordu
A réception je règle le plateau.Après une première impression le plastique ne colle pas.Après 2 réglages je me suis rendu compte que la plateforme était tordue...
Z**R
Does the job it is intended to do and resistant to heat
Used for my 3D printer. Arrived on time and was exactly what I had ordered.
A**R
Comes right off without even applying force
Great upgrade. It was first stick to bed with bed temperature set to 60°C for PLA. Wait it to cooldown like other comments said and it comes right off without even applying force. Adhesion is good when printing.
Trustpilot
2 months ago
1 month ago