FPVDrone 224mm HD 5 inch FPV Racing Drone Frame Carbon Fiber Quadcopter Frame kit for DJI FPV HD Unit

nice features. >the air unit is annoyingly close to the flight controller but it works fine. maybe 3/4 of an inch from 20mm FC to air unit or 1/2 of an inch from a 20x20 4-in-1 ESC because of the bat lead pads. there is not enough room for a 50v capacitor if you need to solder your battery lead to a 4-in-1 ESC. 30v cap will fit though. >camera is well protected. easy to adjust and keeps the adjustment well. >frame very stiff. >seems like it would hold up very well in a crash. >internals are well protected. >dji antennas are a pain to install in the holders (you have to force the SMA down the tube with a small pick) but they seem very sturdy and i think it would survive most or any crash. the antennas have to make a tight corner to plug into the air unit when everything is installed so its a pain to take in/out. you dont have to take the air unit out to access any other components though so once its in you can leave it. all the air unit I/O is accessible. >the air unit holder and the antenna guards are 3d printed soft-bendy plastic. print quality is rough but works fine. seems like it will hold up well. time will tell. >there is a lot of empty space in front of the FC which makes the quad back-end heavy, it is not balanced. maybe it would be with a go-pro. not something i care about but you might. i would recommend this if you have an air unit. feels very solid. best frame ive tried so far (out of many). after flying this build for the first time i am ordering another one of these frames for my next build.

Excellent clone. So good that geprc should really be worried. All the plates mate perfectly, all the hardware is high quality. Lots of room, good crash survivability and very light. Probably the best frame ever made.

It was very easy together, with being to kinda understand how to read a scmadic. When you are used to instruction Manuel. However I think it’s false advertisement that this is for a DJI air unit. Cuz no matter where I put the 03 system I could not fit it anywhere. And the little cage it comes with just makes it move and wobble. Other then that I like it was easy to build and how light it was compared to Flyfish frame.

A lot of bang for your buck, for the 40 bucks I paid, it certainly did the job. Everything mounted fine, held fine, and even had enough tucks and hiding places to tie things like the receiver and a walksnail vtx on it all while having a small slot for the xt60 cable to come out the top for a sleek look while plugged in.....but that antenna holder, idk what its printed with, but that idea needs to be beefed up or reinforced at the connection points cause its extremely thin and frail. the top gave out on a minor tree crash, and the lower part gave out who knows when but it wasnt in a crash. Id buy again, but replace that part with rubber or something stronger. the frame itself though, definitely held on. Had a nasty crash from high up onto concrete and jammed a motor in but didnt even scratch the arms or frame.

nice and sturdy, easy to assemble survived drops and hits and still flies. only damage I made to it was from motor wire that got stripped from insulation and started to short somehow - but that was my fault

Good frame. Very durable. Word of caution the vista unit has a camera cable too short to fit in this frame. I had to mount my camera and air unit up front rather than using the location intended in the frame.

Haven't crash tested it yet but it is solid and fits whatever you need while still being super low profile

Good frame for the money buy it says it's a 5 inch frame but it's not it's only a 4 inch frame would not have a problem with it if it came as seller posted it as a 4 inch or if they sent 4 and 5 inch arms with it