Eightwood Aluminum Enclosure Electronic Project Box Case for PCB Instrument Amplifier DIY 3.94 x3.94 x1.97 inch (LWH)

Quick delivery and use.

Yup... 94.8 mm x 100 mm for a board outline that will slip into the pcb slot in the base. Copied from a previous review... Trust but verify... Verified! It's exactly as you'd expect from the photos. I put a 94.8mm x 100mm PCB in it and it slid in perfectly. This is the perfect size enclosure if you have tall components and also want to keep the board size inside the 10cmx10cm limit to get really cheap boards from china.

Just as discribed .would buy again

With removable ends and top, projects can be mounted to the box and accessed with ease. Aluminum makes a great heat sink, and I mounted a variable voltage regulator on one end and two insulated female jacks on the opposite end, one for input voltage, and the second one for output voltage. Project was made for a specific voltage, so no access was necessary for voltage adjustment. The aluminum box is not sealed or waterproof, but project was made for in-house use.

This is an extruded aluminum box, comprising two halves that slide together and two end-plates that screw on. The fit and finish is good. We took off a star because one of the eight screw holes that hold the end-plates was not tapped. Luckily, I have the correct metric tap in the garage. We are using it to house two solid state relays; being aluminum, it will not only protect the operator from shocks, but it will serve as a heat-sink for the SSRs.