Dolphin Automotive Automotive DPS400 Reverse Parking Sensors Auto Express Award Winning In 32 Colours 4 Ultrasonic Radar Sensors Kit Audio Alert System Matt & Gloss Black +30 More Colours (Matt Black)

Measure twice, cut once, plan your cable route, easy to install if you have good diy knowledge. Connect red wire to reverse lights with scotch lock or something similar.Tip- For a 20 plate Corsa, the live wire in Blue.

Good product

I have bought it in grey ( clear ) color but doesn't mach the grey colour of my car , works fine , looks ok , sounds nice not enjoying but can be adjusted when fitted ( cost at the garage £100)

Good value compared to other systems out there shopping around. Ordered one set for rear and one set with switch for front. Tools required to fit are all supplied the rest is down to you and some basic DIY skill is needed with wiring up the rears correctly to come on with reverse and wiring the front in with switch also, and marking out the sensors correctly to drill the bumper if pre marked holes aren't present on the inside of bumper. But easy enough to do if careful and some youtube videos can watch also to help.

The warning bleeps not loud enough

Sensors were easy to install and very good quality

I fitted these to a 2002 Honda CR-V. I can’t say it was easy, but probably no more difficult than other similar products. I had to use the angled spacers/washers that come supplied because the bumper is angled upwards where they need to be fitted. Maybe because of this, the sensors aren’t perfectly flush to the bumper, there’s about 0.5mm gap in places. When you push them in, don’t push the centre, push the surrounding ring.I tapped into the live feed of the reversing light as instructed, but tapped into an available earth wire rather than a metal body part.I can’t understand why the power and earth leads are simple wires, meaning you should really strip the live to the reversing light and solder it in. I used Posi-Tap connectors which made it much simpler and results in less damage to the car’s wiring. In my opinion, Posi-Taps should be included in the box. I would recommend getting some if you’re taking this on.I would also recommend watching every YouTube video you can find on the subject, especially if you can find ones specific to your make and model of car.I’m no auto electrician but I do have limited experience of messing about with motorbikes. Also my car isn’t worth much, so the risk was low. If you have no experience of doing stuff like this, and/or your car is worth quite a bit, I would suggest finding a professional to do it for you, or at least a knowledgeable mate. It took me about 5 hours. The bumper had to come off, and most of the boot interior and trim (it may be easier on your car). I’m cream crackered now!Bear in mind, there are lots of weird little plastic clips that hold bumpers and trims together, and they break if you force them or do it wrong.To be honest, the instructions aren’t up to much. Theres more info and instructions on their website, and on the Amazon ad, than there is in the box. Do your research. Read and watch everything you can find. Then maybe get someone else to do it for you ;)Oh, they do work btw, so I’m happy. Overall, good value.

Good sensors, easy to fit. But the colour is a lot lighter than pictures on amazon website.