Kapitan Towel Bar Rail - 50 cm / 19.7 inches, Stainless Steel, 3M Self Adhesive OR Screws Mounting, Bathroom, Kitchen Rack, INOX 18/10, Polished Finish, Made in EU, 20 Years Warranty

The rail has simple clean lines. I used the supplied screws to fix mine as I don't trust glue.If I want to be picky a paper overlay to help square and mark up drill holes would be usefull.

It would be helpful for the seller to not only show the back of this product but also the measurement between the brackets which is key. All they give is the overall measurement but I found that the fixture to the wall did not tally with the fixtures of the towel rail I was replacing.

It fits on wall extremely well if you follow exact instructions.

The towel rail is used to hold the towel and tea towel in the kitchen. Was what I wanted and a good size. Solidly made.

Looks well made and just for a change an item not from China. It looks fine and well made, however tried sticking it on smooth wall tiles in our downstairs loo (did it properly i.e. cleaned the surfaces etc.) but it still fell off after a couple of days (only a lightweight towel on it).Have since done it the really proper way with plugs and screws so all now fine.It's ok enough that have just ordered it's bigger brother for the shower room.

We needed a towel rail for the toilet/shower room on our Broads cruiser. Space is limited and this appeared ideal. It seems quite lightweight, however the size is just right and it was very easy to install. In a domestic installation, I would suggest that it is more suited to a cloakroom, than a bathroom, due to the size and capacity.

Very Sturdy and good price for stainless steel. Only thing is the caps. If you are drilling into hollow plasterboard after the tile, you will need to use a 6mm alligator wall plug. I used a screw a bit thicker than the ones supplied and shorter. I had to get a hammer with cardboard in between and bang the cap into place as there is no way you can do it with your fingers, it keeps popping off! Be careful as the caps are very thin metal and it will dent. Would have been better if the caps were screw on like a lever on rose door handle then they would be easier to take off if you need to tighten in the future. Also, one side comes reversed but you can if you undo the with hex key you can make it on top. Measure first with bar in between, then unscrew bar off, so that the holes are straight and you you are able to screw the screws in, otherwise the caps with inhibit you from doing this. But altogether much happier with this. Looks good and is secure.

Easy to install but would not place a heavy towel it but ideal for a kitchen drying towel.