BANG4BUCK 2Pcs 10mm Car Front Windshield Wiper Washer Sprayer Nozzle Replacement For Chevy GMC Cmary Toyota Corolla

The factory and proper replacement windshield washer fluid sprayers for my van were made of plastic. In the harsh Michigan Winter, it's hard to not hit them with a snow brush while clearing the windshield. Inevitably, I hit them and they break. that's when i decided to get these sprayers. Although they are not an exact fit, the fact that they bolt on instead of clip in means they are a lot more durable and will stay in place. The metal construction means they won't be damaged if I accidentally hit them with a snow brush!Unfortunately, less than a month after installing these windshield washer fluid sprayers on my hood, my engine blew up. Although it is highly unlikely that replacing the windshield washer fluid sprayers could cause an engine to fail, post hoc ergo propter hoc tells me I can't ignore the possibility. Buyer beware!

Definitely a lot of BANG for the buck. Installation is/was easy and, all you need is a sewing needle to adjust the direction of the spray onto your windshield. NOTE: You should always aim for the lower 6-in the roof line as, wind will force the spray downward anyways 😉

Installed easily and is working perfectly. I did need to enlarge the hole on the hood slightly with a Dremel but of course others may not. Quality is excellent, I can't believe I went 3 years without a windshield washer. The price is very reasonable, original equipment can be unavailable or surprisingly expensive.

Easily installed and very low in price, they work good enough, each head has two sprayers. The problem I have is that on each head, one of the sprayers sprays good and straight with a nice flow, while the other sprays wildly and acts as if it’s a bit clogged. If it was only one sprayer out of the four, it would be a easily ignored but it appears to be a manufacturing error on both heads.

I bought these for a 2000 Mazda Protege. They're sightly too large to fit, so I widened the holes in the hood using a 3/8 inch drill bit, and then painted the edges of the holes to prevent rust. Then the new nozzles fit work great. It was much cheaper than buying the nozzles meant to fit the car.

Worked great for needing to put them in a custom spot because of the spray adjustments. Wish they would spray the fluid like normal, instead it's more of a shooting stream. Had a bad sprayer and they sent a replacement right away. So that was nice.

Easy to install and cheap, Easy to adjust horizontally but no dice vertical. Just hits the lower portion of the windshield

I used these to replace mine on my 2000 Corolla. Easy install and they've held up fairly well for the price.