Hogue HandAll Beavertail Rubber Grip Sleeve for SIG SAUER P365

This fits perfectly for my P365. Takes a few steps but I made some hot water in a coffee cup through the Keurig and it took no time to install. Looks great and feels great once installed. Thickens the grip to fit your hand better.

Great quality. Fits perfect ! Easy to place onto stock grip with little effort ! Looks and feels awesome !

It takes quite a bit of force to install this. I just ended up using muscle power and nothing else, but the instructions recommend using Windex or some other lubricant to install. I stretched it out to get it initially on the frame, then grabbed it on one end and PULLED, then alternated to the other side and PULLED again, after about 5 minutes of alternating each side, I managed to get it in the correct position.Once you get it installed it is a wonderful grip. Matches my P365 perfectly and makes the correct grip very natural and comfortable. Its made out of a VERY TOUGH rubber material with a great texture. The "Beavertail" on the back cushions the recoil of the firearm (which can be a bit jarring on the P365, since its so small). It is surprisingly affordable for such a high-quality grip, a very good value.

Hogue makes grips from oil and solvent resistant rubber, and I have them on several of my everyday carry guns. IF you follow the directions carefully, you'll find it takes a bit of muscle to install the HandAll on the P365, but it's not as difficult as you may think. The fit is, as expected, perfect, and it makes this micro 9mm much easier to grip.Absolutely no interference with the magazine release button, or with the magazines. Feels great in the hand. I'd highly recommend Hogue's HandAll for the P365.

Good fit. Easy to install. Helps alot with grip.

It's a pain to get on but once it's on, it's completely on. They recommended Windex to lubricate the grip sleeve but I found that hand sanitize works even better.How to:-Boil/heat a cup of water, let the grip sit inside of a cup for 5 minutes.-Slap on a GENEROUS amount of hand sanitizer on the grip module.-Put the rear on then stretch the front on. This step is by far the hardest part.-Wiggle into place and boom, it's done!The goods:-It has a small palm swell and fits very nicely in your hand-It doesn't bulk up the grip too much, just enough to make it feel like you have a full gripThe bads:-Due to it being rubber, it grips onto your clothing when you draw from a concealed holster (for both IWB and OWB)-The beavertail creates a hotspot on the webbing of your hand if you shoot for a long time. I used it for a 500 round range session and although it made a more secure grip, I think I'll have to modify it a bit more to make it not hurt the webbing between my thumb and index finger

I was slightly apprehensive after reading some of the horror story reviews about it not fitting or tearing. After reading over the instructions, and then following them exactly, the installing part went rather well. I soaked the grip in near boiling water for about a minute, slightly stretched it, and repeated that twice. Making and using the shoehorn cutouts was rather easy. Although, if you use window cleaner to lube it, I would recommend removing them after you get it halfway, as they do more harm then good at that point. After that, just work the grip into place slowly until it's where it should be. All in all, it took maybe 10 minutes from opening the package to finished.The grip is nice. Very form fitting to my hand and gives it a nice look. Very pleased with the performance after using it at the range. Definitely worth the price, especially if the stock grip feels somewhat lacking to you.

Works great. A much more friendly grip. Warm it a bit in a cup of hot water. A little soap inside the Hogg and on it goes. A little wiggle goes a way. Just like sliding on new bicycle grips when we were kids.