Winunite 32.8Ft(10M) Car Door Edge Guards Black, Fits Most Vehicles, No Glue Required, Fade-Resistant, U-Shaped Automotive Trim Car Door Edge Protector for Trucks SUV Sedans

This is some of the best edge trim I have ever used. Installation is super easy. Clean the area being covered and install by tapping in place with a soft faced mallet or a wood block and cut to correct length. The material is smooth and attractive . The fit is very secure with metal inside to hold shape. Cuts fine with a pair of side cutters or shears. I used some of the extra to trim some unfinished edges on my aluminum boat. I would recommend and buy again.

Why did you pick this product vs others?:I use it on the cutouts in standalone server cabinets to protect the wires from chafing. This is much better than the standard plastic sheaths.

These door edge guards are well made, relatively thick textured plastic, and are pliable enough to mold to bends in door. There is no adhesive (used in thinner door guards), however they hug the door edge tightly. They are noticeable, thick, black guards, but seem to be capable of protecting the door edges from damage.

bueno

phenomenal product, very easy install and great esthetics. looks very clean on my black Toyota camry

Metal clips hidden within layers of the U-shaped rubbery plastic channel gripped my car door edge very firmly. I pushed it on by hand and then used a short scrap piece of 2x4 to firmly rap in all the way on. Then just to be sure it was on all the way and evenly, I laid the narrow edge of the 2x4 across the edge of the installed door protector and GENTLY rapped the 2x4 with a hammer, working my way along to make sure it was fully and evenly installed on all four car doors. Start to finish, the whole project took less than 20 minutes. And it looks like it was installed at the factory. Because of the sping clips within the black plastic, the installed door protector holds onto the car doors very firmly. After applying this door edge protector to all four doors of a 2025 Chevy Trailblazer, I had about 1/3 of the door edge material left over, so one package of the stuff should be enought for full-sized vehicles with four doors.

I only just installed this trim so I can't speak to longevity, but I am very happy with the product at this point. It looks and feels really good. Installation was super easy. Just pressing it on with my thumb got at attached well and following up with a rubber mallet did help to fully seat it. There was plenty of trim left over, and the price was very reasonable. My truck looks really sharp now!

EDIT: I am updating this to 3 stars as proceed with caution. The seller was responsive and met me halfway to address the damage to my car doors. I would consider this more of a permanent addition if you have a car with thinner paint like Hyundai/Kia. I also applied it to my wife’s 2019 Mazda 3 and removed it to clean and there was no damage to the clear coat or paint. Overall it seems to come down to how your factory paint is done and if you ever plan to remove it in the future for more than cleaning.Original Review: If I could go back and never put this on my car I would. Put on a brand new Elantra N to “protect” the doors and it ended up causing more damage in a single week than any chip could. I am now looking at over $500 of correction which on a brand new car. I would have been better off just leaving it be or putting PPF. STAY AWAY IF YOUR CAR IS NEW. I’ve emailed the company and waiting for a response and will update this when I get an email back. My car got very dirty yesterday and I removed these to do a proper clean and wax and found that it completely screwed the clear coat, causing lumps. Look at the photos below if you need proof.