AF Dynamic Black Cold Air Filter Intake Systems with Heat Shield 2007-2014 Compatible With Accord 3.7 V6 0714-AT-HS_1

***update*** check engine light did pop up for code p0420(cat converter bank 1). I did clear it the first time but it popped back up. After driving the car for about 2/3 days with light on it disappeared on its own. After doing some research looks like the ecu needed to relearn the air/fuel mixture which took a few days to happen. So as of now no CEL again and car is running awesome. Be patient if u do get a CEL.So far, so good. Had another cheap eBay intake and kept getting check engine light for maf sensor code. Installed this one and so far it's been good. Have only had it for a little over a day but the other intake threw the code within one day of commuting to work. Not yet on this intake. I will say even after driving 40+ miles to work I checked the intake and it was cool to the touch. Not super hot like the rest of the engine bay. I haven't really felt any gains but def some nice sounds when u step on it. I'll update if engine light pops up.

Used on my 2008 Honda Accord V6, works well and did not throw codes. Sounds good and throttle is quicker to rev.

Easy install and sounds pretty decent on the car

First and foremost, I definitely enjoy the sound. You can hear every growl, roar, and whistle the engine makes.I don't really notice any change in performance, I wouldn't be surprised if it reduces performance from sucking in hot air from the engine bay. But it sounds faster Haha. If you think this will save you gas, good luck going light on the throttle after you install it.Low rpms aren't any different. I notice it starts growling around 3k rpm then it quiets down until around 5k+ rpm where it's a very load throaty growl.I notice that Amazon doesn't list this when searching for intakes compatible with my car (Honda Accord V6 Coupe 2012) and I'm surprised I found this at all but I'm glad I did (Amazon is sneaky that way). I definitely recommend this over the $300 K&N, and especially over the $250 Afe which doesn't have a heat shield. You could probably fit this with a K&N filter and it'd be the same thing as the $300 one.I'd recommend this if you really care about the sound of the engine, and/or enjoy working on your car. Just don't expect more performance or save more gas.

Great quality nice packaging did notice an improvement on top end. Fits the 12 Acura TL 3.7 but some directions are missing and slightly off. If you have done any work on cars you'll figure it out just fine. 95 percent of the directions are good

Where do I start...-The over spray on the inside of the pipe was so rough and dirty it took over an hour of gradual grits of sandpaper just to smooth it all over and clean so I don't suck chunks into my engine.-the cutouts for the maf looks like someone tried to use a butter knife-there is no "AF Dynamics" badge on the piping or anywhere but the box 🤔-the couplers were so dirty out of the box with a piece of grass and what looked like dry mud splatters, needed to be washed-there is much more assembly than should be required on the customer's end, especially for the price of this "budget" intake .. the filter is just junk as well.-there are more insignificant complaints but these are unacceptable issues to send to a customer.I never write bad reviews but I'm utterly disappointed with this. The only good thing about this is that it makes your car make noise and that can make anyone happy I suppose.

It's great! I was a little skeptical because the price was much lower than the competition but everything fit perfectly. The growl of the engine is quite a bit louder now and sounds awesome.

My intake I received didn't really make any difference. And when I informed the company about it they automatically gave me a refund no questions asked and let me keep the intake. Now that's service. 👍👍