LS1 LS6 LSX Oil Pressure Sensor Relocation Kit C5 Corvette

Typical failure of the oil pressure sensor on the LS6. Definitely easier for next time it fails. While you’re at it, swap your knock sensors, the harness and your intake manifold gaskets. Take lots of pictures and don’t be in a hurry.

Installed this on my 2002 Corvette and this was an AWESOME investment to minimize the work of having to pull the intake manifold to change the Oil Pressure Sensor if it goes out again down the line! One thing to keep in mind though is that you'll want to get some yellow plumber's tape and add it to each of the connections to prevent leaks, but after I put that on at each point this adapter was smooth sailing. From the pics you'll see how the sensor was originally buried at the back of the block and I relocated it to the top using the adapter which will make a sensor replacement take 2 minutes instead of 2 hours. #Genius

Leaked really bad line was not clamp well

Great product!

Oil pressure sensor wouldn’t seal, put an o ring in the fitting. Works great now.

Perfect fit in my 98 C5. The oil pressure sender is a big deal to get to. Installed this and now I can swap that crappy sensor out in a minute. Be prepared to cut and extend the wiring harness though. Very simple job, three wires some solder, heat shrink and wire loom. I zip tied it to the fuel rail harness and it looks like it was supposed to be there from the factory. (Should have been!)

A must have for Corvettes and F-Bodies since the oil pressure sensor is so hard to get at and they tend to fail often.

The concept and idea are good, but did not fit my OE oil pressure sensor. I had to grind down the length of sensor in order to get the gasket to contact and seal. If there’s another sensor that should have been used, no info was given and no directions supplied.