KP KOOL PRODUCTSGas Can Spout - Gas Can Long Flexible Nozzle | Screw Collar Cap (Coarse & Fine Thread-Fits Most Cans) with Vent Cap, Gas Can Strainer, Durable Gasket & Spout Cover - Pack 1

They worked okay they fixed some gas cans that didn't have spouts and the air valve

Worked great. Great product.

At first i was amazed how better this is then stock but after some time it leaks a little no matter how tight the seal is . Its not a big deal to me because original one use to leak more . I would buy again

The assembly was promising but turned out to be as bad as anything else. The threads onthe jug tend to be shorter in some cases than the thread. The rubber seals usually shift off the seal when filling or refilling the jug. Solution is get a jug with a proper nozzle, lid, and tube.

I bought these because the two new polyethylene gas cans that I bought have spring-loaded pour spouts with safety interlocks. The spouts were constantly falling apart (plastic retaining tabs in the spring-loaded mechanism were deformed and wouldn't hold) so I found these.Everything about these things is marginally usable. The seal is prone to leaking if it's the tiniest bit out of position when you screw the spout on. You won't know it until you go to use one, at which time it will dribble some fuel. Unscrew the spout, adjust the seal, tighten the spout. That usually fixes it until the next time you fill the can, then you get to spill another dribble of fuel.The vent caps have a tendency to pop open and occasionally fall out entirely. At least they're yellow and easy to spot.The spouts get the job done but are pretty floppy. Problem is, you usually need both hands to handle a 5 full gallon gas can, so pouring without spilling becomes an exercise in creativity.The caps have plastic rings to hold them on the spout. While this keeps them from getting lost, the rings bind on the spout when you screw the caps on, which means that capping the gas can is a two-hand job (one hand to spin the cap, another to wind the retaining ring around and around).I'm giving these things 3 stars because they fit and don't leak (once you get the seal in the right place, that is). In other words, they meet the minimum standards for usability. They work just well enough that I won't spend the money to replace them, but that's not saying much.

nothing

I spilled more gas with the "safety" nozzles that came on my cans. Replaced ALL of the nozzles on ALL of my cans with these! They work great and I have has 0 problems with them after a couple of years of use!

Works great. No leaks.

These are rather hard to bend making it difficult to use, especially when the jerry can is full.

No more slow fuel transfer with the glug, glug, glug. Using a step drill it is very easy to drill the holes then the vent plug is pushed in. Works great and refueling is much faster. The longer spouts work great as well and each has a screw on cap. I highly recommend this product. The only drawback that I found was that the package was sent from the US thus the delivery window was slightly longer than anticipated.

Good product

Not impressed, longer than stock but cracked as soon as I bent the spout.Cap threads are off, seals do not fit properly.

Perfect ! Thank You !