Thinvik Tubeless Bike Wheel Rim Tape Advanced Series,Bicycle Rim Strip Tape Width 19/21/23/25/27/29/31mm x Length10m for MTB &Road Bike Wheel Carbon set-23mm

Only used it on one wheel but seemed to work well....but note the one wheel I did was set up for tubes, not tubeless.

I use these for making my rims tubeless ready. They are just like all the other brands that have tubeless tape products. These are thick, they provide an adhesion to stick to the inside of the rim. The seal is really good.

I utilized the 19mm tape to convert a pair of Reynolds Solitude wheels with a skinny 18.5mm external width to tubeless. The tape performed flawlessly. There is sufficient tape to complete the conversion for at least four wheels, potentially even five.

Tape is working as needed so far. Taped up a set of ENVE 4.5 AR wheels. Tape Width was perfect. Wheels holding air better than the stock ENVE tape now with this stuff.

This product could be fine for people with an appropriate rim. It did not adhere well to my Light Bicycle carbon rims, which were thoroughly cleaned with acetone and lightly scuffed with scotchbrite. I applied the tape with extra material in the center hoping that it could accommodate the bead relief, but it did not react well to heat-forming. The material would become tighter when heat was applied - peeling off the rim surface - and then fail completely. I will be going back to Gorilla tape. This product may work well for aluminum rims, but carbon is right out.

I have been using Gorilla tape for my tubeless rims because of the cost but this tape is reasonably priced and does a nice job.

I cleaned the rim as good as can be done. I used a clean micrfiber towel to wipe it off to be sure it was clean and dry. There was no adhesion at all on this tape. No matter how hard I pressed down it popped off as soon as I let go. I used duct tape to hold it in place at the start point. Then I went once around. When I took the duct tape off so I could continue, the entire roll of tape came off of the rim. No matter how hard I tried I could not get this to stick, even after several attempts. I paid almost $50 for 4 rolls of this. When I finally got around to taking this out of the package I was past the return date. Don't buy this tape.

If you have observed the shop, or some videos, no reason to pay a crazy price to tape your rims. Just focus; use correct tension; don't shortchange any necessary surface prep/cleaning.

Everything ok.