Geekpure 10-Inch Whole House Clear Water Filter Housing - 3/4" NPT Brass Port-Fit for 2.5" x 10" Filters (1)

I added a outside showerI have solar heated hot water panelsI needed a filter that was easy to install/maintain/affordableExactly what I wanted

Brass fitting on the top where you connect a brass threaded fitting cracked when tightening and flooded out my kitchen. This product failed due to poor quality of metal parts. I would not recommend this product as it failed to perform without flaws in construction and materials used.

Using 2 of these in line the existing water filter on my RV. At first it seemed that I was getting very poor flow through the new filters. Turned out to be a bad check valve on a quick connect I had installed. Swapped out that QC and everything is fine. Cannisters I added have 20 and 5 micron filters, existing filter in the RV has a 1 micron carbon filter. At 45psi, everything inthe camper works peachy.

The good: brass thread inserts are great, all of the plastic is solid, wrench seems sturdy enough, the clear sump threads go inside the cap instead of outside, which should offer better support and reduced risk of failure. Clear sumps have a reputation for breaking and these just might last longer because of that design decision.The bad: the pressure relief "button" is not a button, nor is it usable for pressure relief. It's a small screw with tiny threads directly threaded into the plastic of the cap. If this filter was mounted with anything overhead (like a bracket), it would be nearly impossible to relieve pressure with this. I took one out, put it back in, and when trying to gently snug it, the plastic instantly stripped. I used a screw with more aggressive threads to hold the o-ring on that housing. Luckily, my system already has a pressure relief and I didn't need the pressure relief function to work.If you don't need pressure relief and are tying into 3/4" pipes, these look excellent. If you do need pressure relief, look elsewhere.

Purchased to create my own DIY 3-stage filter system for our travel trailer. Worked great. I like the clear housing so you can see when the filters are ready for change.

Not good bracket holes did not match filter I had drill the 2 front hole to make it work I did not pipe it up for water yet

Replaced the “proprietary” Forest River 10” in line filter in minutes. Note 3/4” brass sleeve inlets REQUIRE threaded 3/4”-1/2” brass reducer!

The supplied screws are too big for the holes, causing the plastic to crack. I found some smaller screws that worked, but then discovered the cannister leaks massively around the main seal, even with "the O-Ring be properly seated in the O-Ring groove".The flavor was not bad.