Petrichor Nest Thermostat Wall Plate - Compatible With Google Nest 2020 - Trim Kit, Cover Accessory for Easy Installation - Charcoal

Bought this to cover up the old screw holes left by the old thermostat. Works well compatible with my google Nest and easy to install.

Was properly packaged, easy to install, and is functioning as advertised/expected. Compatible with Alexa platform…Acid test; I would buy it again.

Basically brand new. No stickers for labeling my wiring but I didn’t really need them.

Arrived quickly and as described. Fit perfectly.

Too expensive for what they are- but they make a nice finish on the wall and hide any imperfections where your old thermostat used to be

Worked perfect, covered up the holes from old thermostat as intended.

The Nest thermostat fits into the wall plate cover nicely, and it was easy to install (less than five minutes). If you already have the Nest thermostat installed, it's helpful to take a picture of how the wires connect into the ring behind the thermostat before you remove them.Steps:1) Gently pull the thermostat off the wall - it will snap off of the ring.2) Take a picture of how the wires connect into the ring so you can reconnect them correctly later.3) Push the tab for each wire connector and gently pull the wire out.4) Use a screwdriver to remove the ring from the wall.5) Fit the ring into the wall plate cover, then place back on the wall and screw it in with the same screws you removed in step 4.6) Reinsert the wires into the wire connector using the picture you took earlier as a guide.7) Snap the thermostat back into place. Make sure it's firmly seated.That's it. You may see a couple of messages on the thermostat like "provide stable power source", or "WiFi not connected", but those went away within 30 seconds and then I could see the thermostat in my Google Home app again.

Great for covering up holes from previous thermostatA little big, but the color matches exactly to the nest thermostat good stuff