LANMU 2 in 1 Micro SD to SD/Micro SD Card Extension Cable Extender Adapter Compatible with Ender 3/Pro/3 V2,Ender 5/Pro/Plus, CR-10S and More 3D Printers(5.9in/15cm)

Funciona muy bien

I tire of losing micro-sd cards whilst inserting them into my 3D printers. I have had to use surgical tweezers to get them out. I had to disassemble my newest one to get the micro-sd card out of it. I have to use a very bright light and readers to make sure that the card is oriented. Smaller is not always better as regular SD cards still being used. To that end, I needed to find a way to mitigate losing more micro-sd cards. These adapters make my 3D projects easier to print as I can quickly insert/remove. The length could be shorter, but that is an annoyance only on my part.

I use a lot of these for all kinds of devices. 3D printers, ODEs for old game consoles, single board computers, etc. It's very useful to move a tiny microsd slot to an accessible location.These are a must if you frequently swap cards as it will put all the wear and tear on this low cost extender instead of the slot in your device.This has both slot sizes if you don't want to deal with an adapter or can't find one. Works well with all cards I've tried.

These would've been nice to work with had they been a bit smaller and less stiff

photos on a micoe sd card will play on the photo frame, but the same sd card inserted in this unit will not display the photos and the frame indicates no photos found. defective and returningI purchased two of these and the first one was as described as above. The second one worked as expected and worked with both standard and micro SD cards.