Replacement Precision Springs Pruners, Trimming Scissors Part for Heavy Duty Bypass, Pack Contains Two Pcs, Shears Spare

Perfect fit on Red Handled 8 inch Hi-Point Brand Pruner. Snapped right in & works perfectly.

Look sturdy, haven’t used yet. I purchased these to use on pruners I had to set aside cause the spring had popped out. Was nice to find these.

Works. Not sure what seller means by "tapered at the ends" but...not what I thought "tapered" means. These springs are uniform diameter end to end. Diameter of spring I replaced was larger at one end than the other. Smaller diameter end fits over a "pin" and into a well. Larger diameter end fits into a well only. So after a couple of failed attempts to seat the spring onto the pin and into it's well, I had to squeeze the pin end of the spring into a smaller diameter with a pair of pliers. And that worked. Now the spring I replaced was made that way. Smaller diameter on the pin end. That's "tapered" to me.

They are only 1 3/4 not 2 inches. Had to stretch the springs .

Dimensions shown online are different than actual.

The spring did not fit my Corona BP3130 well. It allows for some workability for it like maybe 75% but if you "open" the shear too wide, the spring will detach a bit. The material is pretty good/durable if it fits your pruner shears though.

These are too big for Fiskars #379451-1002 SoftGrip Pruner Orange.

I lost the spring to my hand pruners. This fit perfectly and I get an extra one in case I lose it. The length is actually as described (~1.75 inches) and the outer diameter was 0.5 inches, inner diameter 0.25 so it fit the slot perfectly. It's also better quality than the original spring which was lower gauge material.