Uncle Mike's Swivels QD 115 MCS 1" Black

I got this for a beater $99 ATI Tac PX2 shotgun. It was very easy to install and is very secure. The coarse threaded sling attach screw went right into the pre-drilled hole that the ATI shotgun has in the stock. I used a center punch to mark the center of the magazine tube cap so the drill bit wouldn't walk, drilled it and then installed the clip-in attach point to the mag tube cap. Add a sling and you're done. It couldn't be easier and the results are professional - you can't tell it isn't a factory installation.

Works on many shotguns that don't have studs already installed. Not for all models, but works on many.

Well made, instructions are reasonably clear. It's easy to drill the magazine cap off-center - so pay attention to that step. The retainer (snap) rings for the magazine cap swivel work well and allow the swivel to turn as required. Installed on old SKB gas operated shotgun, with no aftermarket magazine caps available. Another satisfied customer.

I used this to retrofit a Browning BPS Upland Special. I had a drill bit with a counter-sink attachment that worked great for the stock swivel- I just rigged up a make-shift jig to hold the gun at the proper angle in my drill press. The various white spacers have two different thicknesses and allow you to screw the swivel in to the perfect depth and orientation.For the front swivel I just carefully drilled a hole through the gun's magazine cap in the drill press. I love Uncle Mike's quick detachable swivels so I can easily go with or without a sling.

I wanted a sling on my new Norinco Hawk 981R/982 shotgun and after researching my options, this appeared to be the set I needed.Overall this set works really well, though I'm not sure how confident I am in the part that attached to the magazine tube cap. It's on there and seems to hold well, but it's not gripping very much material. I do have some concerns about how long that might last but for now it's working.If you have a Remington 870 or Norinco Hawk 981R or 982 shotgun, this should work well for you.

If you own a Norinco Hawk 982 shotgun this is the kit you need to put a sling on it. It comes with the machine screw mount for the butt stock and the hole in the magazine end cap is just right for the mount that takes the press on retainer, i just used the appropriate size socket and an extension and a small hammer to make sure it was seated. The hardest part of the install was finding the right size socket. It only took about 3 minutes to install. It spins freely but feels very secure. I would recomend this to anyone who has a hawk shotgun.

Needed this for my IAC Hawk 982 (Rem 870 clone). Everything worked as intended.Remember, there is a screw for a wood stock (requires a hole to be drilled) and there is a screw for a synthetic stock with a machined hole. Be sure you use the right screw.

870 Express 20 Gauge install successful, no problem. Used the threaded stud and lock washer/nut for the magazine cap. Looks good works good.