Fish Separation Breeder Box, Acrylic Transparent Fish Breeding Isolation Box Aquarium Hatchery Incubator Holder(A-10x10x10cm)

The media could not be loaded. I was a little confused when I first open it, it does not come preassembled, there is no directions and the part are covered in a safety film the made think it was a frosted plastic it was until I began to pack it away to return that I noticed the film.

Would give it 0 stars if I could. This is an extremely cheap piece of plastic and will fall apart with the smallest amount of pressure.The screws that hold it together are sharp so it compromises the fish you have inside the main tank should they swim near it. They also come so far out in the back that you can’t use the suction cups. The lid barely stays in place and is flimsy. The ONLY reason we are keeping it is because we had to use it before we had a chance to return it. The price is 3x more than what it should be.

The aquarium plant box itself is good. Be careful during assembly, the screws are acrylic on acrylic an will strip out if you tighten too much. All that being said, the directions are terrible. Single scrap of paper, not in English and does not cover the entire install.

Easy to assemble. Just look at the picture and put the tabs and screws/nuts on it. Took me longer to remove film off each piece than put it together.

The media could not be loaded. So I do like the product, it is just a bit tedious (not difficult) to put together. I’m adding a video of a 20G Innovative Marine as a good visual. I really like that it is acrylic, beautifully see through, and has perfect size holes that allow for great water flow and just big/small enough for an anemone not to be able to crawl through. It is the only separator I have found if it’s kind, I dislike the Mesh nets as it doesn’t allow for flow and gets dirty quite quickly. The 10x10x10 is perfect for placing clownfish inside in order for the anemone to host them, there is just enough space. Definitely get a bigger one if your fish is going to be larger than 3” inches. I did get a slightly broken piece but it was good enough in order to place the walls together. IF you do get a broken piece I would recommend buying Aquarium Grade Silicone (PetSmart, PetCo, and LFSs should carry it) and bonding the walls or wherever needed. Silicone would look fine and be sturdier. Again it’s definitely the only one I could find that wasn’t a Specimen Box which does not have holes or is big enough and has a top cover and not a detritus gathering mesh net. The only reason I am giving it a 4* is that it is tedious to put together and they should include 2 or 3 spare pieces just in case.

The whole item Is weak when. You put it together it's not tight the lid comes open the suction cups are very cheaply made the whole box is a waste of money spent. I don't have pic because I trashed it after my guppy got out as soon as I placed it in the box

I'm not sure why people complain about the not being instructions. Looked at the photo in the listing and assembled with no issue.Only recommendation is to take off the safety film BEFORE you assemble. I didn't realize there was film. Just assumed I got a cloudy version.My ADF tadpole loves it

NOT as pictured! Cheap, off white semi transparent at best. Hard to see my fish inside and not what I wanted but it’s more cost and trouble than it’s worth to send it back so I’ll make do 🤷🏽‍♂️P.S.Absolutely no instructions, so be good at puzzles and have a Phillips screw driver that works well with plastic nuts and screws.