Revenge Golf Cart Parts & Accessories Golf Cart Rear Seat Kit Safety Grab Bar

I think it should be noted that this a "custom" fit for a seat back that was made by Madd Jaxx seat kit. It fit perfectly although one of the bolts was a little too short to put the lock washer on. If you do NOT have the Madd Jaxx seat kit, you will have to drill holes and get the corresponding nuts to attach to the seat. I still give it a four star because it is a good, well made item that shipped quickly. Everything as advertised and I would recommend having one on your cart if you have passengers and are on the streets at all.

Great accessory. Had to really work with it, to install; as it was slightly off, with manufactured holes to match up. Seller was willing to replace, if necessary, so there was great Seller communication and customer service. Finally got it to work, and it looks great. Really helps for any rear riders to have something to hold onto, or to balance against, when exiting the cart. Worth the purchase.

The grab bar had some rough powder coat under the curved top. I had to sand it down and spray some black paint on it. No big deal. It fits well and is very sturdy. Bolted right up my Madjax rear step.

Ordered from Golf Cart Kings and received the grab bar within 4 days! It was also the MadJax branded with the horizontal bar up top. It was simple to install and included the hardware (4 bolts and 4 flat washers)....install took about 10 mins. You may have to remove some screws that secure the rear bumper as it causes some interference.

Hooray for not falling off the back of the golf cart!Make sure you measure before you order, receive and install this though...make sure you have enough room to flip your seat over if that applies.

Was not as pictured. Did not have the plate near the top. I made one. Other than that, durable and useful.

Very easy to install on my E-Z GO RXV. The rear foot plate already had the required holes for the bolts. Gives my passengers a little peace of mind. Pass along to older adults that It isn't meant as a climb-assist bar...

My only problem was that one of the nuts was welded on crooked so I am not able to get the bolt thru that hole.