🔗 Connect, Create, Conquer!
The SparkFun Qwiic HAT for Raspberry Pi is your gateway to the Qwiic ecosystem, featuring four Qwiic connectors for easy daisy chaining of I2C sensors and accessories. It is compatible with any Raspberry Pi that utilizes the standard 2x20 GPIO header, providing convenient access to GPIO pins while fitting seamlessly with Pi Tin enclosures.
C**Y
Great for connecting up Qwiic devices!
Does exactly what it's supposed to and worked VERY well at that!
C**N
Rememeber that RPi board layout changed over time, check your GPIO header pins
Tossed it on a RPi4 ran i2c detect got bad output and a little concern that I may have toasted bus location. Also realized that I had to run it upside down and out of the case because RPi 4s have the breakaway section on the other side. TMYK Great board though, but it's SparkFun, you knew that.
M**S
Works, but probably not what I wanted
I’m new to this stuff. I didn’t realize a hat plugged right onto the pins on the motherboard. I was hoping to use a ribbon as my project also uses the breadboard. Plus I’d have to Dremel a hole in the case. What I really wanted was a split T adapter so I can still use the breadboard/gpio and have dedicated i2c connectors as well. In the end I used male pin wires (from the i2c wire kit) to connect off the breadboard. Make sure to buy the wire kit!!
A**R
you dont get whats in the picture
it would be great if it came with the cable shown in the picture
Trustpilot
1 day ago
1 week ago