for Xbox One Elite Replacement Full Buttons Bumper Triggers T6 T8 Screwfor Xbox One Controller with 3.5mm Jack (Chrome Gold)

I primarily bought this for the shoulder bumpers. When I tried to use any other part from this package, I could not get the controller back together properly. I finally removed the shoulder buttons from the Xbox button cover and used the chrome ones with my OEM Xbox button cover and made it work.They advertise for Elite controllers, but all of their buttons and D-Pad switches are for the regular Xbox One controller....they are not magnetic.If you need shoulder bumpers, save some money and just buy those to replace on your controller. I would not recommend this product.

Don’t buy it. If I could give this zero stars I would. The bumpers work fine until you put on the plate that holds everything together around the power button. It is so tight it pushes the bumpers in so tightly, they are always engaged. Not only did I mess with it so much to put it together to figure this out... I now have to solder the vibration mechanisms back to the board because I messed with the wires too much trying to get this plate on. ONLY to find out it’s too small. So I tried the factory black one, slightly better but I still can’t even depress the bumpers. Honestly I should really just buy a new controller at this point. HUGE thumbs down.

The pieces themselves look cool when placed in the controller... but be forewarned... Taking apart an Xbox controller is a bit of a nightmare! We only installed one piece due to the complexity. With as expensive as a controller is, and the possibility of ruining it just to get these pieces in...I wouldn't go there!

Everything fit accept the bumpers, triggers, and the gold around the x. The bumpers broke altogether where they have 2 holes that line them up and the coating is inconsistent and blochy on the gold around the x

Really great... But not for the elite controller. I used it with the original control the Xbox came with the non Bluetooth one.

Horrible plastic broke had to get a new one which didn’t fit right, had to Frankenstein it between parts and they want me to send the first piece of junk back which is a pain. Not recommended.

The bumper assembly (the piece I specifically needed) DOES NOT FIT THIS CONTROLLER EVEN THOU IT SAYS IT DOES. I had hoped that reassembling the whole controller would snug it up in the case, but it just caused the bumpers to stick in the active position, so I had to take it apart and put it back together multiple times. PARTS ARE NOT FOR THIS CONTROLLER

Alright so one thing as a consumer I failed to do was read exactly which model this was for. So I bought these buttons for my 1708 model contoller. The most of the buttons fit on it except for the bumpers, triggers, home, and sync button. Be careful they do show fingerprints and smudges.