MakerBotSpools of PLA Filament for 3D Prints with Less Part Warping and Curling (10-Pack, Small)

Great offer

In general, this PLA is pretty good with the exception of the yellow. Right out of the box it was brittle and would often break while inside my PTFE tubes, even after storing it with desiccant. In addition, the yellow definitely has poor dimensional accuracy, which doens't help when almost any resistance causes the filament to break.The other colors were fine, and after breaking up my prints to do multiple shorter prints in yellow it did work and adhered well to my BuildTak bed (though again, yellow didn't adhere as well as the other colors, though it wasn't terrible either). I'd buy the other colors again, but not the yellow.

I shout it was the big roll of filament.

Great variety of colors

Great color selection. Prints are a little stringy on an Ender 5, but that may just be settings. Not a great deal weight wise, but again, good color selection. Further experience has shown many print failures where other PLA has worked great. I have tried a variety of print temperatures, but between being too stringy and regularly lifting off the bed, it's not a great material to work with at all. Bad weight, bad results, and now an elevated price. You decide, but I won't buy another of this brand.(EDIT) My primary problems were with the Red color in this batch, and the Blue wasn't great either. It may have just been a bad couple of spools. The other colors have on the whole printed well, so I have changed my review to a 4 star. This PLA NEEDS to be at 210 C, but even there, the Red did not perform well for me. I have so far used up 3 of the 10 spools, and used a good portion of 3 more, so I think over all this is an accurate review of this PLA. I will answer any questions you post about this product as I want to support the growth of this industry. Such a cool hobby.