PWS Primary Weapons Systems Keymod Harris Bipod Adapter Polymer 5KMHBEA1 Plastic

Great product. Solid bipod mount. The bipod swivel is screwed into the middle keymod lug, which means it would be impossible for this adapter to come loose while the bipod is attached,(no need for loctite). On the Springfield Armory Saint, it's the perfect height for the bipod legs to clear the forward handstop (which is built into the handguard) when the bipod legs are folded forward.My only complaint is that the instructions were a little unclear. They say to loosen the two hex screws, but don't mention loosening the middle keymod lug (by turning the swivel mount). It is possible to attach it without loosening the middle lug but if you do so it isn't flush against the rifle. Maybe it would have been obvious to others, this was the first time I used a keymod attachment point.

Installation was slightly annoying but once installed it is very secure and works very well. overall quality is good and the design itself looks like it will hold up without any problems in the future. its surprisingly sturdy and when tightened down it is very secure. i do not doubt this will have any issues holding up to abuse for a long time to come.A single con is that it does not fit very flush to the rifle. i have the adapter pictured attached to a cheap but effective bi-pod.

Absolutely great product, but unfortunately I had to return it. Didn't work on my application. I am using the seekins keymod rail and the front slots closest to the muzzle have a qd sling mount on the 3rd slot. So I would have had to put the mount behind the qd slot. It just wasn't what I wanted to do. But like I said it was a great quality product. Just make sure you have 3 open slots where you want it.

Works perfect to attach a bipod or sling to my Keymod hand guard/forend. Base is plastic, but the hardware locks in very tight and is strong. Includes an allen wrench for a quick two minute installation. Note, both screws and the stud must be loose in order to secure the mount. There is an instruction/installation card in the packaging that explains how to install the mount.

For being a polymer, it holds up well. I use it to hold a set of Harris bi-pods for this particular AR i installed it on. It remains sturdy from all the swiveling I do when using the bi-pods.

great but pricy at 32 bucks. Cheaper ones fine for general use, but if I was back on a ship or shore, would probably not mind spending the money as much.

Outstanding piece of equipment, was skeptical at first, being that it was made of plastic. First and foremost, fits excellently into my key-mod grip, low profile, keeps the bipod from looking gawky. Very solidly mounted, well made. Made in the good ole US of A. Hard to break so far. Yes I abuse my equipment, it's just the way it is.

The KeyMod bipod adapter works great on my AR15. It is plastic and not metal. I wish I would have known it was plastic.