Caddx Mini FPV Camera EOS2 Turbo EOS2 4:3 1200TVL 2.1mm FOV 160 Degree 1/3 CMOS NTSC for FPV Quadcopter Racing Drone by Crazepony

We bought this product for our first 250 mm build and have only had it in the air one time. But from what I can see so far for someone new to the sport and have only used one other FPV set up before, thus far this is a big improvement in visibility. I know that it is my fault for not doing the research for understanding the difference between a mini and a micro camera, this camera was a little bit too small and we do not have any adapters for this but we did make do using standoffs to accommodate the extra space.This camera does not come with any mounting brackets or housings, you only get what you see in the picture including two screws. I am not upset in the camera performance and quality, this is why I gave it five stars. But having a bracket come with this camera would have been better

I got this to upgrade the stock camera on a BetaFPV 75x. It works well and is a nice improvement over the stock camera. You'll need to cut the connector off of the end and solder the 3 individual wires to the 75x VTX.I highly recommend the camera. Also had a really good experience with the reseller when I contacted them with a minor issue.

Camera arrived with one wire broke away from solder joint apparent before removing from packaging. When i picked camera up by the housing i could easily tell the other 2 wires were barely attached. While carefully peeling back the rubbery liquid tape another wire came loose. I reattached the 2 loose wires and added a dab of solder to the third that was barely on as well. The camera with repair is working and the picture is great. Crazypony sent new camera and I am so happy! This company is amazing. I was wrong b4 and I now know this company is very trustworthy and has customer service that truly cares.

Begin here: I’m a retired electrical engineer. Not bragging. I have insights that most do not. Assume nothing.The micro cam is a micro electronic marvel ... if connected correctly.There is little latitude for guesswork. I guessed and failed. Micro circuitry is intolerant of overload, over voltage.There was no user info, specs etc supplied with this camera. ZIPPO. I had to dig on line to find “some of it”. (After the fact). I found that this camera is designed to operate at 3.5-6VDC.. I never did find specs on the MA drain of this camera. Went into it blind. Camera is now toast. My transmitter board outputs 12VDC to the camera. It shut down. That maybe dorked as well. Further tests needed.You are on your own with this. Nothing is common between cam and transmitters. You figure it out.I resolved this by buying a matched pair- cam+ transmitter. Appears to work well.Good luck- Have a nice day

Best little camera I have run, great picture and easy to install. This thing is a great solution for such a little package and price, will purchase again and again

I bought two of these. the first one, i burnt up immediately because this camera requires 5v to power on. so i bought another one, got it all connected and did a test flight. the color bleed/saturation is horrible on this camera. I was using a cheaper camera than this and it had way better clarity and color/contrast. When you use this camera, during sunset, the red hue from the sunset and trees just bleed together and makes it hard to tell what is what.

My son had asked for this for his birthday to add to one of his drones he flies around in the parks or mountains weekly. He said he was very happy with it and it took.wonderful picturesThey were very clear and showed precise details over the area he was filming. Well worth the price.

I’m definitely enjoying the 1200tvl clarity!! The only bad part is it doesn’t do the greatest in low light and the plastic lens.