XiKe 2 Pack Garage Door Torsion Spring Stamping Steel Bearing 1" ID x 2" OD, Used with Center Support Only.

We were the right size and seemed durable.

Great 👍

Was not able find snapper zero turn mower front wheel pivot bearing that would fit, the garage door bearings happened to be the correct size, both inner and outer, worked great on the snapper front wheel pivot bearings

these are good for replacing the plastic bushing in center of the two car garage door, but do not work too well for end bearings. the casing is soft metal and if you're going to be pressing or hammering these into the brackets you will crush casing and make bearing useless. i'm glad I ordered 4 even though it clearly says they're not meant to be used for this purpose. I ended up using some large sockets and Dremel to open up the hole a little after beating out the old bearing. I destroyed three of these before finally getting one of them driven in without damaging the case. in my case, the bracket I need is not available anywhere, it needs to be about 2 1/2" shaft offset, the smallest I saw is 3"+. I think if you need end bearings just buy the bracket even if offset is larger, but then you may also need to replace your drums to larger diameter drums and the center bracket to match the new ends

Good bearings

Fits good, great price! Delivery person was in a Coma though, no fault of Item.. Amazon won't allow you to rate deliveries now.. I wonder why....

Great product and perfect fit

These work great, but had to buy two packs of them to have a fitting pair. The circumferences differed on each to where one would not work per pack. This seems to be a common occurrence per the reviews.