Barrington Hardwoods Walnut Lumber Board - 1 3/4" x 3" (1 3/4" x 3" x 18" (2 Pieces))

Exactly what I needed. Couldn’t be better.

Not much to say except that they are good quality, defect free. I’ll definitely be buying again!

Good cuts, and great pieces of wood. Great smell, great quality lumber. If you are looking for some lumber of this size I would really recommend these pieces they are great and are a good price for the two pieces.

Though pricey for two pieces, the cost of labor for them to be ready for your project at hand, is priceless! These pieces were ready for my project without having to do any wood work to them!These were the ONLY pieces of the size needed for my project, though 1” less in thickness was preferable. However, still, I have no qualms on the final results.I like my 1st project so much, I re-ordered the item again!

Lumber look great, shipped fast to meThank you

A significant amount of sapwood on one face and edge of this board. Luckily I’m face gluing to another board to make a thicker piece. And the edge will essentially be the top of an apron against a tabletop so nobody will ever see it. I lucked out so I can t be mad. But when you’re spending a lot for a small amount of project ready wood you expect it to be the highest quality. I personally don’t think walnut with any sapwood should be sold in this fashion but that’s just me.I also was expecting it to be 4" wide for some reason. I guess I didn’t read the item. This will also work out fine because now that I think about it 4" is probably too wide for my project. But that’s all my fault so I can’t dock stars for my illiteracy. Everything else was fine. I dodged a bullet with the sapwood but others might not be so lucky. It’s only because of my weird construction and how I am using this piece that it’s going to work fine for me.Again, when you’re buying a small piece of expensive wood that’s supposed to be project ready you’re paying for premium. 20% of a 2 x 3 x 18 board being sapwood is not premium. This board is quite small. And for it to not be completely clear is almost funny at this price. The price per board foot on these small pieces is crazy high. And s4s is worth about 50 cents per board foot at my local dealer.

Boards were cut slightly out of alignment. needed a jointer to bring the boards back to alignment with each other. I guess there was no indication that they were a matched set, but they were...

half of the board was sapwood, for what I was making I needed consistent color through out the entire piece.