Donner Flat Patch Cables for Guitar Effect Pedal 6 Inch Save Space Clear Sound 1/4" TS Right Angle 3 Packs

Great Cable

Delivered on time and with care.

I needed connecting patch cables that didn't take up very much room in order to fit my pedals on my pedal board. After trying a few different kinds, these turned out to be perfect, the best of all of the options I tried. Not too long, with flat angled plugs that fit pretty snugly against the pedal. They seem substantial enough that they aren't going to go bad.

I recently posted this review: "The ends are too big/bulky, and the cords are not flexible enough. Go with the more expensive, EBS cords." I have since realized I spoke too harshly and quickly regarding these Donner patch cords. I have been using a home-made pedal board and running all my cords ON TOP OF IT, creating an unholy mess! So of course, I had too much trouble cramming the Donner ends next to each other on the stereo ins/outs of some of my pedals. I have since redone my board, and it's amazing how much easier it is to get all the cords to fit when you run them underneath the board! (Ha) Yeah, these Donner cords could have smaller ends and be a bit more flexible, but if you run them underneath your pedal board, they work just fine.

great value for the money

Donner products are well put together before the money great value

Unusable space is the bane of every pedal board. These patch cables allow the pedals to be just about as close together as possible so you can maximize usable real estate on your pedal board. They are pretty short compared to my other patch cables, but this also helps maximize space. Just dont expect to get much distance out of them. Feel pretty durable, and the flat wire design also adds to their compactness.

I already own 24 different style Donner Patch Cables. They are the Right angle style, 12 @ 15cm & 12 @ 30cm! Theses Donner cables are fantastic and seem to be quiet and flexible. If there’s one issue with the Right Angle style; it’s the width of the head of the plugs. It doesn’t allow side by side cables to be attached on Some pedals when two are needed like for an expression pedal or a stereo set up. That is why I bought the 15cm Flat patch cables. The smaller head allowed me to complete a stereo set up between my Chorus and Reverb/Delay pedal because the head is thinner. The sound quality seems equal to the std. round cable. I just can’t justify the triple the cost for the Mogami patch cables when I’m using so many...12/14 pedals X 2 inputs. That would be a small fortune for me... I’m a Donner Fan for Life.

Used them on my pedal board. Took me a while to figure out that a backgroud noise was due to the one connecting my noise gate to the amp. I replaced with a high quality jack and noise gone. So obviously not the best choice, at least for me

Super quiet cables that are flat and utilize pedal space. Highly recommend

I wanted to try these out and they turned out to be better than i expected. They're very flexible and being flat cables they save space on pedalboard.

I like the low-profile 90 degree ends on these, and the plastic covering keeps them from scratching surfaces. The cords are flexible enough, although there's a slight wedge shape to the ends that wastes a few millimeters of space if you put two side by side on a patchbay.

Cheap and gets the job done.