Light Bar 36'' 16 Flash Modes 32 Led Emergency Strobe Warning Lights | Directional Bar Hazard Warning Flashing Safety Light with Led Display Screen Controller(35.5 Inch, Yellow/Amber)

This light bar is perfect for a wrecker driver! Super bright, lots of different patterns to choose from, easy to install. The traffic advisor function is a lifesaver for working those middle of the road breakdowns or working against oncoming traffic. The hardwire option is nice so you can tap into a fuseable link and then mount your controller however you’d like. I didn’t utilize the suction cups but instead set it on top of my dash (Peterbilt 379) and used self-tapping screws behind the light bar to hold it secure.

For taking pictures late at night, on and off of the roadway this light is plenty bright, lighting up all surroundings. However, when it's daytime, just as car headlights become less noticeable, this does as well. For the brightness, it gets a 15/10 at night (8/10 during the day- Wayy better than nothing). In terms of installation, unfortunately there are *NO SUCTIONCUPS* included, however it would be easy to pick some up & stick it on. For me, it made the most sense to simply drill it into my ceiling with anchoring screws since this car is a beater work vehicle. As for the actual wiring, you may need to learn a thing or two. For me, I wired it into my radio fuse (15amp) using a fuse tap with a 3amp fuse (Be sure to check the fuse diagram for your vehicle). From there I grounded it to the frame of my car under an existing bolt, making sure it would be safe from fire/sparks. *(this install did require me to take off my dashboard). From there I was able to run the wires through the car under the trim, all the way to the back, with about only 6 inches of wire visible. Whole thing took me about 4 hrs to figure out, but maybe this review will help you be quicker! Stay safe, stay in the law, and have fun!

As long as you're good at routing wires, this light is pretty good for its cost. (I installed this light on the back if a Ram Promaster 1500). I did have to cut the wire to avoid drilling a large hole that the connector could fit through. The first light was defective and they promptly sent a replacement. Great customer service. The light mounts pretty easy and is easy to operate. Again as long as you have the wherewithal to drill holes and route wires in your vehicle.

Nice TA, only issue I had is no suction mounts and i had to buy a cigarette power adapter from Advanced Auto. The thing is bright, even though my tinted rear window I can see it at least 20 feet or more. The pattern selector is a bit bright too. All in all a good buy, just wish it had a non-drilling mount option and power source attached to the pattern box for the bar. Woulda been nice in Amber/Green instead of amber/white.

Light came with a mount, but I chose to put suction cups on it instead and suction it to the back window. The suction cups I got suck. The light keeps falling off the back window, but the install was fast and easy and the light is pretty bright! No problems with the light, just the suction cups that I got.

Purchased this light bar and it works exactly as it should, very easy to install and very bright, when the light bar arrived one end was damaged, reached out to the seller as I needed this lightbar for December 5th and the seller made sure I had the parts to make repairs, cannot recommend this company enough, they go way above and beyond for the customers

I am a experienced installer. It did not come with any suction cups. I had gotten them separately along with a lighter plug. Wireing the plug was difficult I needed a third hand. But I managed. I never cut wires. A foot too long is better than a inch too short. Placing the bar in the back window of a Mission Versa was very cramped but I managed. Hint. Moisen the suction cups with window cleaner. This accomplishes two things. 1. It creates a strong suction. 2 while the cups are still wet, you can slide the bar around to get it centered and level. Once it sets it is difficult to remove. 3. Get a plastic scraper. When you need to remove it place the scraper gently under the cups keeping in mind the rear window defroster grid is delicate. I have installed any is these. It take patience in both wiring the plug and getting the bar in the back window properly. If you are going to hard wire and drill it into the back window assembly be careful when putting the connecting wire under the carpet. In my case the light is completely removeable. Just pull the plug and break the cup seals. I have a dash light and lights under the traffic advisor and a magnetic light bar on the roof . I can remove the entire system in a few minutes. I know this is long but if you have never installed anything like this I hope this helps. Good luck.

I guess you get what you pay for. This light bar was good while it lasted. Very bright, but then after about 13 months of less than normal use the light went very dim. Here is the sellers response when I inquired about any warranty: Feel sorry. The warranty period has expired. Our warranty period is one year. If there is any damage during the warranty period, we can replace the product for you.

it showed up faster than expected despite the delivery warnings and also the sellers lag time in answering questions and it is exactly what i needed and install was excellent and easy with the mechanic so yea its fine

Nothing more to say. The device shorted out after only two uses. Absolutely ridiculous. Thankfully,I I had the foresight to wire it into a terminal that only has power when the ignition is in position II otherwise I might have found my car burned out. Very disappointed. Stay away from unbranded vehicle lighting. No valid BS mark or legitimate CE marking. No quality control. Totally unsafe unit.

USED FOR CONSTRUCTION PICKUPS AND WORK WELL

i have an issue with the controller not working, i have tried many times to contact seller to resolve-im being ignored-beware of products coming from this seller