Evolution S14MCS 14" Mitering Chop Saw | Cold Cut Steel Saw | EVOMAX Intelligent Motor & Blade | 3500+ Blade Life | Burr-Free Finish | Shadow Guide | +/-46° Miter | Soft Start | Reinforced Base

Everything is nice quality and heavy duty . Very well thought out and engineered. Cost a bit yes but I think its well worth it . Easy to assemble. Cant wait to use it !

This thing works GREAT! Leaves a machined like finish true to square and repeatable. Fits my category of, “money well spent”. My neighbor has been using the previous version of this same saw 4-5 years in his machine shop and it still cuts as good as my new one. The stand for it is a good balance between weight and stability and allows me to move it out of the way.

Wow, this saw cuts metal great. Somewhat expensive for someone like me that does not need to cut metal often but then again, cuts are now straight and smooth vs crooked and wavy from my past without this saw.

Works great

Cuts miters on Sch 80 pipe like a dream. I should have bought this sooner

If you have ever cut metal before this will blow your mind, "OMG" Indiscribable! I had a minor issue with my shipment from seller, and they resolved it instantly when I notified them.. this is a great product and an awesome company 👍

I more or less knew what I was getting into before I bought it. A buddy of mine had one about 6 or 7 years back when they first came out, basic model. It’s a hefty price tag but worth it. Can’t say I notice much difference in speed over a traditional abrasive saw but i don’t push it anywhere near as hard either, it’s smooooth. Just go slow and let the saw do its thing. Cut some 4” schedule 40 (1/4”) pipe with it. The noticeable difference is being able to pick the piece up bare handed IMMEDIATELY after the cut. It absolutely does make sparks, but very few in comparison to an abrasive. It also does make a hell of a mess and I need to make sure my 2 year old doesn’t ever go in the garage without shoes now… but the cuts have virtually no blade walk. 2 cuts were exactly square all the way around on both faces. One cut had a single plane that had .003” blade walk over 4.5” distance. Thats pretty impressive. I’ve used $20,000 cold cut saws that took nearly 40 hours to shim everything right during install and still be off more than this saw. Time will tell on the blades but after a couple dozen cuts, zero noticeable blade wear. For a $1,000 saw on a portable dolly table… it just doesn’t get any better than this. Only cons are, I wish it had a shop vac port and some skirts like my m18 miter to catch some of the mess, and I wish it had a dual clamping fence instead of screw clamps.

Everyone should have one in the lineup

it make amazing cut i really like it for smalll metal