BIQU CryoGrip™ Pro Frostbite Panda Build Plate for Bambu-Lab P1S P1P X1C X1E A1 3D Printers, Cold Printing Build Plate, Double-Sided Textured Spring Steel Sheet, 257x257mm, 1 Piece

It is banded unable to use with my printer bambu lab p1s. So pls replace it as soon as possible

剥がれづらいので良いです。 それでも剥がれちゃった場合はこのプレートで温度上げて使ってます。65℃ぐらい。それが良いことなのかはわからないけど問題なさそう。

Muy buen producto

Best printer bed I’ve ever used. I have my printer in my basement so I deal with a lot of humidity. I was having some issues with the original bed for my P1S so I was looking and this seemed to be the best option. Boy let me tell you this thing is GRIPPY, since I swapped it out I never had an issues with bed adhesion. Everything sticks like glue I never have to glue or try and change the temps in my printer for any type of filament, just have to wipe it with a small amount of soap and water and it’s back up like new. Fits perfectly for your specific printer, I will 100% be buying another if I need it this thing is amazing.

this plate turned out to be the best for me and no glue needed. Only issue for me is Bambu printer cannot read the bar code so I just have to ignore the error message. I also used this plate to do a leveling

Literally everything sticks to this plate and is easily removed. After many many uses I finally had a face down black print stain the blue bed. It hasn’t seemed to affect any other prints at all, however. I wish there was another solution with a better texture than the glossy finish it leaves on your print but not a deal breaker. I used this bed the most in my P2S. I’ll buy no other brand than this one and the stock one.