Easycargo 30mm Fan 5V 3.3V DC Quiet Fan for Raspberry Pi 5 4 3B+ 3007 (4-Sets)

I purchased this fan on my third attempt to get a working 30mmx10mm fan for my Vilros Raspberry Pi 4 Model B starter kit case. The Vilros fan that came with the case was dead-on-arrival. The second fan that I ordered directly from Vilros directly was also dead-on-arrival. At that point I gave up Vilros fans and ordered this Easycargo fan. Fortunately this fan worked perfectly on the first try and was really quiet. In fact it cooled my system temperature down from 45C to about 33C in just a few minutes. You should be able to see that in the attached netdata image. I am very happy with the performance and quietness of this fan and highly recommend for this setup. And, although I cannot vouch for its lifespan because i have only been running for a short time, I can safely say that has run far longer than either Vilros fan. Also, this fan does not have the blue control wire to allow it to be toggled on and off but it runs so quietly, that is not an issue for me. I also want to say that, except for the fan, I am very satisfied with the Vilros Raspberry Pi 4 Model B starter kit and would recommend it.

You could hardly hear the fan. 5 stars.

Product was as expected. Only real issue is that the box has a totally different heatsink product image on one side, and then this product on the other. Confusing until I opened the box! Works as expected, easy to setup.

Pretty slow airflow, but it certainly does the job and keeps my pi below 60°C even at full load. Doesn't take much power whatsoever, so it's not too hard on the power supply. Cheap, simple, small, not much to say about it.

Great set of fans, but I do not have a raspberry pi... I have a Sony XDR-F1HD HD tuner. These have a known problem with overheating and not starting up the next time they're turned on. A fix is to install a fan blowing on the internal electronics. This little fan is an ideal fit - I "glued" it inside with double sticky tape and connected it to the 3.3V power supply inside the unit. This fan is very quiet and inaudible with the cover back on the tuner, and it starts up reliably now. I know this is a bit of a corner case use, but if you need a little fan that doesn't need much voltage and is super quiet, check these out! Oh, and if you're actually doing the same Sony mod I did, the service manual is available - just google it!

Works great. Easy to use. I made a dual fan cooling system for my Sony a5000 camera. This keeps it cool very well. No jitter and it is totally quiet. Highly recommend!

Fit's my case perfectly. It runs quietly when placed horizontally or vertically. It makes a tiny scratching noise when tilted. My RPi v4 stables at 35.0'C ~36.0'C.

Fit right into pi case, going strong

Bought to use as cooling fans on my rc cars. They work well and are comparable to many of the more expensive ones .

per il prezzo va più che bene, il cavetto è un pò corto e va bene solo se si vuole mettere la ventolina sulla scheda

Ottime ventolone 5v per il mitico raspberry pi 3, appena montata la ventola è silenziosa se mantenuta pulita e fa il suo dovere. La temperatura del rasp con ventola montata in media è 35° considerando che senza ventola è arrivato anche a 55 60° posso dire che funziona benissimo avendo la necessità di raffreddare un rasp h 24

Perfectos y silencioso

Sarebbe importante sapere a quanti giri girano le ventole cosi ci si fa una idea di quanto raffreddano, comunque è un buon prodotto e costruito bene.