Jescar Power Lock Plus Polymer Sealant - 16oz - Durable High-Gloss Paint Sealant for Long-Lasting Protection – Easy Application, Safe for All Paint Types, Easy to Apply, Hand or Machine Application

Been using for a year now and have applied to 5 vehicles and this stuff is outstanding in terms of finish gloss, protection and longevity. I have been detailing cars for over 50 years and this is my go to product now for a starting sealer. Tried many products, including but not limited to Chemical Guys Jet Seal, Meguiar's sealer which does leave a white residual on black plastic which a lot of cars have nowadays. This Jescar sealer comes off black surfaces easily with no frustration and effort, not like most other sealers..I could tell how tough this product was when I tried to wash out my microfiber removal towel and found you can't get this stuff out. This is the first product I cannot wash out, so your microfiber towel will became a trash rag afterwards which is an OK sacrifice for me to have a great finish. The product is a little pricey but can do at least 4 cars. Make sure your surface is clean and not full of contamination for a better result. Run your fingers along the surface and if you feel grit or sandpaper like particles in the surface then you need to use a clay and lubricant to remove the contamination before the sealer for a better result. On a clean surface apply a thin layer -- wait one hour -- then buff out. That's it. Enjoy!

Very pleased with the results. First time using this product. Bought based on positive reviews for the 'first wax' on my new BMW X1 (Vegas red paint color).Highlights would be ease of rubbing off once dry and the high-gloss shine that results.Only negative for me is that it's somewhat more difficult to apply than similar products - a bit too thick and gummy. It's not impossible to apply by any stretch, but just isn't as pleasing to apply as you're not entirely sure you're covering all the areas (though I suspect I did based on the end result).Would buy again.

Long time Zaino user, and once you get used to that system it does perform incredibly well. However, the two part mix and shake was starting to get old, especially when that darn activator bottle dries up and you still have tons of sealant left, and need to shell out twenty bucks +S&H for another little activator kit. So...I've been trying this.Application was almost as good as Zaino. Zaino I found to be easier to apply very thinly, where this seemed to need a bit more on the pad. If you get a good thin coat with this though, it almost disappears completely when it cures, but you can tell by finger that it's on the paint. Areas which are a little too thick don't buff out quite as easily, but still easier than most. The re-apply windows is longer than with Zaino, but I don't waste as much and it's not that much of an issue.The shine has been very good, and I'm getting good life out of it. I have two months of salt and snow on the last coat which I'm about to run through a wash once the streets dry up, but I'm still seeing good beading on the hood using two coats with recommended intervals between.I'm past the age where I want to spend every weekend detailing my car. This looks great, it works great, it's easy to apply. I take care of my vehicles, and this is going to make that process less chemistry set. Also I'm a chemist, and i want less chemisty polish, go figure. If push came to shove, I might give the edge to Zaino, but it's in the realm of who cares your vehicle is going to look fantastic if you have good paint/prep/care.

I was looking for something not in the ceramic line but that would be durable and easy to work with. Had been using a typical wax product for many years and read about this product and it being a sealant instead of just a wax I thought I would give it a shot. I prepped the panels with an alcohol panel prep before use and then applied with a DA machine. Very easy to apply and removal with a good microfiber cloth was super easy as well. Left a super slick finish and great wet look. I would definitely recommend this to any skill level as it is very easy to use.

Works similar to paste wax, but much easier install and way more longevity. Beads well. Goes on and comes off easy.

Excellent product. Superior protection. Easy to use.

Good stuff. So my S6s ceramic coat had essentially worn off after 2 years. With it being middle of July in SW Florida the humidity and heat won't allow me to correctly apply my ceramic. So I opted for this to get me through the summer and fall until I can apply correctly.I also did my buddies Mustang convertible hence the pics. So far I am impressed. Gloss is good, easy to add and remove (just wait 30 mins).I applied it to glass well, I haven't driven in rain yet, but my buddy did and said everything beads very nicely.I recommend for those inbetween ceramic coats if the environment isn't cooperating.Will keep in my arsenal of products

Got this for my auto detailing business - really easy to apply and buff off. Looks super slick and lasts for several months typically. Not quite a ceramic, but close if you don't want to go through all the ceramic prep.

This product if really easy to work with and delivers exceptional results. I used it to bring back the gloss on an old boat hull. Boy did it ever do a nice job.

Vert easy to apply and buff. Fantastic glass like finish. Works on boat hull, windows and isling glass. Better than wax won’t oxidize

Recommended by Drake's detailing. It is worth the money.

works good