H/D VGA DVI Audio LVDs Controller Board 30 pin for 17" 19" 1280x1024 M170EG01 M170EN01 M170EN06 M170ETN01 1 LCD Gaming Screen Panel

I used this to modify my 1up Arcade, and then sold the arcade for a nice profit. The device worked wonderfully. The monitor is Model # M170ETN01 1. If you are using this monitor with this adapter, it will work great. The power supply on the 1up will fit into this adapter. Hint, the red wiresm go on your left side with this adapter and the 1up M170ETN01 1. The white ribbon wires will stay in the same place (these connect to the board with the buttons) You can ditch the other part as it is not needed with the 1up Arcade. Please check the model number of your monitor to assure compatibility. Not all monitors in the 1up have the same model number. I included a picture with the monitor (model number clearly seen) and the set up I used. Note the power plug, in the picture, is not in place.

Shipped and arrived very quickly. Works perfectly out of the box. Just follow directions on ETA Prime video for Arcade1up. I wanted to offer my experience with the buzzing / no audio some people mentioned. I had the same issue. The problem is not with the LCD driver. It's a configuration setting in the Pi. I had to add a line to my /boot/config.txt file to force the audio to the HDMI output. If you search online for "retropie no hdmi audio" you'll find the answer. There are 3 lines I had to uncomment or add in the file to get the HDMI working. Apparently, the Pi doesn't recognize this HDMI board right off and has to be forced to output HDMI video and audio in the config.txt For the audio I had to add the following line: # May not be needed for all HDMI devices hdmi_force_edid_audio=1 That got my audio working perfectly. Also, be sure to use the audio jack on the far right of the board.

Very easy to install compared to some boards. Just use a a double sided foam tape buffer when installing board to metal backing. You don't want to short out unit .

It works with the replacement screen I found for my Arcade1Up TMNT machine. The quality seems good enough, but the included adhesive pads don't hold well. I had to use additional adhesive to get it to stick.

You don't need the "HIGH VOLTAGE!" daughter board, and you can discard it. I like that it provides you with a board where you can adjust all the monitor settings, and have actually used it to make my cabinet's monitor look much better at the viewing angle I look at it from. Gives you HDMI, VGA, and DVI, as well as a 3.5mm HDMI audio jack, which I use to get audio from my Pi. Nothing bad to say at all about this product. Works as intended and is very simple and straightforward to set up and use!

The board works like it should. Make sure you have a power supply as it doesn’t come with one.

Perfect for home brewing Arcade1up

I purchased this following the same guide everyone else is commenting here, and modded a rampage cabinet to run a raspberry pi. Works great, and has been running for about a week now without any issues. The only thing I wish was the wires being just a little longer, but I mounted it above the screen and it's working great!

It was quick transaction. Kudos and great job.

si é bruciato,appena "collegato"

Bonjour produit opérationnel dés le raccordement,la qualité de gestion de la dalle impeccable je recommande, Vendeur réactif a l'expédition cdl.

Used to convert a arcade 1up machine to use a pandoras box. So simple to install and great picture quality.

To second what other reviewers wrote, this does work with Arcade1up LCD model M170ETN01.1. Just follow the ETA Prime video and you’ll be set in no time. Worked great out of the box, very happy customer 😁👍🏻