Premium Quality Key Hole Hanger 10 Pack With 3/8" x 4 Gauge Flat Head Phillips Screws

The product is fine. Pay attention to the size. These were smaller than I expected but I never really checked the dimensions before I ordered. Screws are very short, don't expect these to take a lot of load. Probably best for a picture frame

Great product. Used them on a shelf, it looks like the shelf has no support. Just what I bought the product for.

The idea is great, but the hangers are a bit light weight. The screws were smaller than I would have liked. The hanger material was aluminum which seemed too light. I would have preferred steel. Note: To use these hangers a screw must pass through the hanger so you will need to cut a recess into whatever you are hanging to make room for the screw head. These require some fitting to use effectively.

8/10 were flat and useable right out of package. 1/10 had a significant burr on one side that had to be removed. 1/10 has a fair bend that had to be flattened. All screws were accounted for and had no defects. Would most likely order again if needed due to defects being minor when compared to some of the others I have ordered.

These are flat stamped with no relief for the Hanging Screw. Mounting screws are short and provide little penetration.

Used these when I made wood a Wood Christian cross. Easy to make the key hole and attach the hanger with tiny screws.

I bought this to hang a heavy plaque, immediately upon opening the package I realized no way these were going to work. Not heavy duty, in fact they are only for light duty applications. The picture shows that they are thick, in fact they look like they are stamped out of very thin sheet metal. They also will not allow for a screw head to slide into position without having to burrow out some of the wood. This is a very misleading representation of the product and a waste of time for me and Amazon to order and return the product.

Bought these to hang wooden window valances I made. Perfect size and strong enough to hold 37” x3/4 stock with no problem.

Some IKEA shelves are using something like this. Very good the only downside is that the screws are not flush once you screw them. I recommend using a press drill and Fortsner bits to make the recess.

Great for small stuff.

These are are for lightweight fixtures and do not even qualify as "medium duty"!