Receiver: Channels/switches: 1 Power: AC180 - 250V Connected device voltage: 1-250V AC/DC (switching output means no voltage comes out of the relay but it can switch the 1-250V circuits) Maximum working current: 30A Receiver sensitivity: : -105Db Dimensions: 75 × 55 × 29mm Weight: 73g Operating temperature: -10 ℃ ~ +50 ℃ Remote: (2 included) Channels: 2 Operating Voltage: DC12V Frequency: 433mhz Operating Current: 30MA Distance: 20-30m+ (please note that is the ideal distance without any block and signal interference, it would rise and fall about 10%-50% with interference). Size: 50 x 40 x 13mm approx (plus keyring) Weight: 23g Add extra remotes by pressing the learning button inside the receiver, then press a button on the remote. The receiver light will flash when the remote is recognised. The control mode can be selected by moving the jumper on the receiver to 1pin only - momentary, 1&2 pin - toggle, 2&3 pin - latched. Latch type: Press the button, the relay is on till you press another one. Just like the wind-speed buttons of electronic-fan: press a wind-speed button, the fan runs at a certain speed until you press another button. Toggle type: Press the button, the relay is on until you press it again. Just like the power key of TV remote control: when you press it, TV on, press again, TV off. Momentary type: Press the button, the relay is on until you release it. Just like the button of Klaxon, if you press it, Klaxon on, and will turn off once you release it. Each device connected will need to be powered by it's own power source. Manual: http://www.safaridrives.co.uk/content/manuals/AC220V-1CH%2030A.docx
Trustpilot
1 week ago
1 month ago
